Dataprobe iPIO-8 Skrócona instrukcja obsługi - Strona 2

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Systemy wejścia/wyjścia Dataprobe iPIO-8. Dataprobe iPIO-8 2 stron. Ethernet i/o monitor and control
Również dla Dataprobe iPIO-8: Podręcznik (15 strony), Skrócona instrukcja obsługi (2 strony)

Drukuj stronę

Web Browser Access

Factory Default IP Address: 192.168.1.254

Factory Default Security Credentials:

Role

Username

Administrator

admin

To access the iPIO from the default IP Address, requires the

PC to be on the same local network (IP Address

192.168.1.nnn). If it is not, change the iPIO IP Address using

one of the methods on the following page.

After pointing the browser to the IP Address of the iPIO, enter

the Administrator Username and Password to access the

complete setup features. Enter the User credentials to access

only the power control. Once the user is validated, the Control

and Status is displayed.

Input and Output status is updated automatically. To control

any Output Relay, click on the Change link adjacent to the

Relay Status.

Changing the IP Address

1. Device

Management

Management Utility (DMU) from Dataprobe's website at

dataprobe.com/support-ipio.

means to find and configure your iPIO for use. It can discover

all the iPIOs on your network, display the current IP address of

each, and allow setting of any valid IP address.

Note:

The IP address can only be set within the first two

minutes of powering up the iPIO. The Setup Utility will only

work with iPIOs on the same physical subnets as the PC.

The iPIO Setup Utility can also be used to return an iPIO to its

Factory Default condition. This can be used to recover an iPIO

with a lost password. Highlight an iPIO from the display and click

Factory Defaults. This must also be done within the first two

minutes of powering up the iPIO.

Complete instructions for the DMU are provided with the

download, and in the full iPIO Manual.

2. Web Page Setup

From the home page, click on Setup, then

Network. Enter the new IP Address, Subnet Mask and Gateway,

then click Save.

Click the Reboot button (or press the reset

button next to the power outlet LED) to restart the iPIO with the

new settings.

3. DHCP

From the Home page, click on Setup, then Network.

Change the IP Mode from Static to DHCP. Click Save, then

Reboot. The iPIO will obtain its network settings from the server.

Check the server, or use the Device Management Utility to obtain

the new settings.

Password

admin

Utility

Obtain

the

Device

The DMU provides the easiest