AGRI-COVER ROLL UP TRUCK BOX COVER Instrukcja instalacji - Strona 4
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Akcesoria samochodowe AGRI-COVER ROLL UP TRUCK BOX COVER. AGRI-COVER ROLL UP TRUCK BOX COVER 16 stron.
Drukuj stronę
1: INSTALLING SIDE RAILS (Continued)
D. Verify side rail is level. If side rail is not
level, perform one of the following:
If side rail tilts up: loosen and lower clamp,
engage teeth and then retighten clamp.
If side rail tilts down: loosen and raise
clamp, engage teeth and then retighten
clamp.
E. Install second clamp on side rail at midway
point. Adjust side rail until flush at top and
then repeat clamping procedure.
IMPORTANT: Ensure clamp teeth engage
side rail grooves.
F. Install third clamp as close to tailgate as
possible. Adjust side rail height until flush
with top of tailgate and then repeat clamping
procedure.
G. If provided, install fourth clamp between
second and third clamp. Adjust side rail
until flush at top and then repeat clamping
procedure.
NOTE: For trucks with electric tailgates,
typically side rail must be installed slightly
higher (approximately 3/16") to eliminate
interference.
H. Repeat Step 1 to install side rail on opposite side.
I. Torque all clamps to 20 ft-lbs or value specified in special instructions (if supplied).
3
Clamp
rd
At rear, this edge
should be flush with
top of tailgate
4
This surface of
side rail should
be level
Adjust clamps
up or down
until they
hold side rail
level when
tightened
1
Clamp
st
2
Clamp
nd
This surface of
side rail should
be level
Adjust clamps
up or down
until they
hold side rail
level when
tightened