Dataq Instruments DI-700 Podręcznik użytkownika - Strona 13
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Sprzęt nagrywający Dataq Instruments DI-700. Dataq Instruments DI-700 20 stron. Software-configurable usb recording instrument
Drukuj stronę17. After W
D
Software installs, the Advanced CODAS Analysis Systems dialog box appears prompting you to
IN
AQ
install the CODAS software. If you purchased this software click on Yes. If you did not - click on No. The Make
Backup? box appears again allowing you the option of creating backups for files replaced during installation.
Click on Yes to make backups or No not to. Installation is complete - you will now see a Successful Installation
box - click on OK to exit W
ID address of each and run steps 6 through 17 for each device.
18. To run W
D
/Lite or W
IN
AQ
double-click on the program you would like to run.
DI-700 Instrument Controls and Indicators
The following describes the user accessible items on the DI-700 instrument.
Instrument Rear Panel
The 37-pin male "D" connector is used to interface analog input channels 1 through 16, eight digital inputs, and eight
digital outputs to the instrument. The analog inputs are labeled CH1 through CH16, the digital inputs are labeled DI0
through DI7, and the digital outputs are labeled DO0 through DO7. Other items include two analog grounds labeled
AGD.
DI-700 Series instruments can accept 16 analog inputs in single-ended configuration or 8 analog inputs in differential
configuration. Single-ended inputs are configured by connecting one signal lead to the desired channel and the other
signal lead to analog ground (AGD) as shown in the following illustration.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
D
Installation software. If you are installing multiple devices, change the Device
IN
AQ
D
Waveform Browser go to the appropriate icon group in your Start Menu and
IN
AQ
Getting Started
7
DI–700 Series User Manual