DV8 OFFROAD Razor Series Instrukcja instalacji - Strona 5
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Akcesoria samochodowe DV8 OFFROAD Razor Series. DV8 OFFROAD Razor Series 14 stron. Razorback hardtop 2018+ jeep wrangler jl
Drukuj stronęINSTALLATION
MANUAL
STEP 7 |
Close the tailgate to prepare
to place the hardtop on the vehicle.
Removal of spare tire will make
installation easier, but is not necessary.
Ensure the rear window glass is in the
"open" position prior to installation.
Once the hardtop is in place, open the
tailgate.
Leave the tail gate open and do
not cut the seals.
With the help of a friend lift the hardtop
and place it on the vehicle in its
approximate location of install.
Adjust the forward/back
positioning of the hardtop using the rear
passenger door seals as a guide.
When positioned correctly:
-The seal will not be crushed
-There will be no gap between the hardtop
and the seal
-The seal will be seated firmly between
the hardtop and door
Then loosely secure the hardtop with the
factory hardware.
-There are six fasteners for the interior
located along each edge of the tub.
-There are two fasteners above the rollbar
towards the front of the vehicle.
There is a short test you can perform to check
tightness/fitment of the door seals against the
hardtop with any dollar bill.
Open the door and the lay the dollar bill flat
against the hardtop where the door will close.
Then close the door so that the dollar is
sandwiched between the door/door seal and the
hardtop.
If you can pull the dollar out with no resistance,
its likely your top needs to be adjust forward to
create a better seal.
If your dollar will not move, or can be removed
with slight resistance from the seal, then you
have created a good seal.
Perform this test in multiple areas to determine if
the seal and fitment is good.
NEED HELP?
855-680-9595