Agri-Fab 45-02102 Instrukcja obsługi - Strona 4
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Rozrzutnik Agri-Fab 45-02102. Agri-Fab 45-02102 13 stron. 125 lb. push broadcast spreader
Również dla Agri-Fab 45-02102: Instrukcja obsługi (13 strony)
Drukuj stronęASSEMBLY INSTRUCTIONS
TOOLS REQUIRED FOR ASSEMBLY
(1)
Pliers
(2)
7/16" Open or Boxed End Wrenches
(3)
9/16" Open or Boxed End Wrenches
1.
Place the spreader upside down.
2.
Assemble the long spacer tube and a 3/4" washer
onto the end of the axle that has the small drilled
hole (right hand side). See Figure 1.
3.
Place the idler wheel (no notch in hub) onto the axle.
The air valve should face to the outside. See Fig-
ure 1.
4.
Assemble one or two more 3/4" washers onto the
axle and then assemble the 1/8" x 1-1/2" cotter pin.
See Figure 1.
SHAFT
SUPPORT
PLATE
SMALL
HOLE
IDLER
WHEEL
1/8" x 1-1/2"
COTTER PIN
FIGURE 1
LONG
SPACER
TUBE
3/4" WASHERS
5.
Place the short spacer tube and a 3/4" washer onto
the end of the axle that has the large drilled hole
(left hand side). See Figure 2.
6.
Place the drive wheel onto the axle. The notched
hub and the air valve should face to the outside.
See Figure 2.
7.
Fasten the wheel to the axle using a 1/4" x 1-3/4"
hex bolt and a 1/4" hex lock nut. See Figure 2.
SHAFT
SUPPORT
PLATE
3/4" WASHER
FIGURE 2
8.
Remove the middle 3/8" hex bolt, flat washer and
hex lock nut from the crossover tube. See figure 3.
CROSSOVER
TUBE
3/8" FLAT
3/8" HEX
WASHER
LOCK NUT
FIGURE 3
4
SHORT
SPACER
TUBE
1/4" x 1-3/4"
HEX BOLT
1/4" HEX
LOCK NUT
DRIVE
WHEEL
3/8" HEX
BOLT
SHAFT
SUPPORT
PLATE