Aussie Concept F140 Instrukcja obsługi - Strona 5
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Myjka ciśnieniowa Aussie Concept F140. Aussie Concept F140 13 stron. Domestic cold water high pressure cleaner
Drukuj stronę
22.
Always keep electrical connections dry and off the ground.
23.
Do not touch plug with wet hands.
24.
To avoid damage to cable do not roll, crush or pull it.
25.
Always inspect the power cable before and after use for any signs of
damage or aging.
26.
Always hold spray gun and lance firmly with both hands so you maintain
full control.
27.
Do not operate the machine whilst standing on ladders. Use scaffolding or
a platform tower. Always keep good footing and balance.
28.
Never spray the machine with pressure jet of water.
circuiting the machine.
29.
To reduce risk of serious injury never point high pressure jet at either
persons or animals, nor at any part of your body. In case of penetration
seek medical attention immediately.
30.
Do not cover machine. Always provide adequate air circulation in the work
area.
31.
Only use a high pressure hose which is approved for machine's operating
pressure (see "Specifications" section).
32.
The high pressure hose must never be crushed, stretched, kinked or
twisted.
33.
Never attempt to move the machine by pulling the high pressure hose.
34.
To reduce risk of serious or fatal injury from electrocution, disconnect the
plug from power supply and relieve pressure to hose before attempting any
work on the machine.
35.
Only carry out maintenance or repairs described in this manual. ALL other
work should be performed by your local authorised Aussie Pumps Service
Agent.
36.
The power cable may only be repaired or replaced by an authorised
Aussie Pumps Service Agent.
37.
Store the machine in a dry place and protect from freezing temperatures
as exposure may damage the machine (follow storage instructions in this
manual).
38.
Use only chemical cleaning agents/detergents approved for power
washing when using the chemical injection facility and never introduce
solvents (i.e. acid, paint thinners, petrol, oil, etc.) into the detergent
injection system.
WARNING - The appliance must be earthed.
We recommend that this machine is connected to the mains switch by a residual
current circuit breaker (earth leakage protection device).
WARNING - Extension Cables
The use of an incorrectly sized extension lead can burn out the electric motor.
Failures of this kind are NOT covered by the warranty.
We recommend the following YELLOW extension cables for high pressure
cleaners which use 10 amp plugs as standard:
-
CLICK - 10m lead P# CHL100 IN
-
CLICK - 10m lead w/integral safety switch P# CHL100 INS
-
HPM - 10m lead P# R2810
-
HPM - 2m safety switch P# R5102
Safety Precautions cont.
Concept F140 Cold Water Pressure Cleaners – March 09
You risk short-
Page 5 of 12