Agri-Fab 45-02112 Instrukcja obsługi - Strona 6
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Rozrzutnik Agri-Fab 45-02112. Agri-Fab 45-02112 13 stron.
Drukuj stronęFor Agri Fab Discount Parts Call 606-678-9623 or 606-561-4983
14. Assemble the flow control arm to the flow control
mounting bracket using a 1/4" x 3/4" hex bolt, two nylon
washers and a 1/4" hex lock nut as shown in figure 7.
Tighten carefully. The flow control arm should be
snug, but should pivot with no more than a slight
resistance.
15. Assemble the vinyl grip. See figure 7.
VYNIL GRIP
FLOW
CONTROL
ARM
1/4" x 3/4"
HEX BOLT
(2) NYLON
WASHERS
FIGURE 7
16. Place a 5/16" flat washer onto the end of the flow control
rod. Insert the end of the rod through the slot in the flow
control mounting bracket and through the hole in the
flow control link. Secure with a 3/32" x 3/4" cotter pin.
See figure 8.
5/16" FLAT
WASHER
FLOW
CONTROL
ROD
FIGURE 8
FLOW CONTROL
MOUNTING
BRACKET
1/4" HEX
LOCK NUT
3/32"
COTTER
PIN
SLOT
FLOW
CONTROL
LINK
6
www.mymowerparts.com
17. Hook the free end of the flow control rod through the
hole in the slide gate bracket located near the bottom
of the hopper. See figure 9.
FIGURE 9
18. Assemble the flow control mounting bracket to the hitch
tube using two 1/4" x 1-3/4" hex bolts, six 5/16" flat
washers and two 1/4" hex lock nuts as shown in figure
10. Do not tighten at this time.
FLOW CONTROL
MOUNTING BRACKET
1/4" x 1-3/4"
HEX BOLT
5/16" FLAT
WASHER
FIGURE 10
19. Place the adjustable stop into the "ON" end of the slot
in the top of the flow control mounting bracket. Secure
with the 1/4" x 3/4" carriage bolt, a nylon washer, a 5/16"
flat washer and the nylon wing nut. See figure 11.
1/4" HEX
LOCK NUT