ADE M400020-01 Instrukcja obsługi - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wagi ADE M400020-01. ADE M400020-01 16 stron. Class iii approved scales electronic chair scales

Drukuj stronę

The ADE chair scale is already been delivered in a fully assembled condition. Please insure that your scale is

being placed vibration free at a dry place.

Alignment of the scale

1) Place the chair scale on a plain, dry and level surface before the weighing of patients.

3) The air bubble in the spirit level should be right in the centre of the circle

4) Please ensure that the scale has no other contact to the floor than by the four wheels after the patient has

been seated onto the chair scale.

Power supply

Power is supplied either by the rechargeable battery in the display unit or by the mains power via the supplied

power unit. The imprinted voltage value at the mains adapter must match the local mains voltage.

After checking same connect the mains cable to the indicator and to a socket.

Note: The wall socket must be located near to the unit and be easily accessible. Please use only the mains

adapter supplied by ADE. The mains adapter is charging the battery pack at the same time.

When the battery is being charged for the first time a sufficient charging period of approx. 24 hours is neces-

sary to achieve a full battery load.

In case the scale is being used with batteries only and the display indicates – Lo, the battery should be re-

charged with the ADE mains adapter. After the first charging period the battery need 12-16 hours. The battery

should be charged while the scale is switched off. Upon completion of the charging period switch the scale on

again to check the battery status. In case Lo- still appears on the display inform your service partner.

Replacing the rechargeable batteries

The battery compartment is located at the front of the unit.

1) Open the battery compartment.

2) Remove the battery cable and the corresponding connector carefully from the housing. Disconnect the

battery pack. Connect the wires/plug (red to red, black to black) with the new battery pack and insert

same into the housing.

3) Close the battery compartment.

Only use original rechargeable batteries and charger units from ADE. The warranty does not

cover any damage caused by using other types of batteries or charger units.

Tips for handling the batteries

The life of a battery depends essentially on the load, frequency of use, temperatures, settings and the acces-

sories used.

–

New batteries or batteries that have been stored for long periods require a longer charging period.

–

Charge the batteries at room temperature.

–

Store the batteries empty (uncharged) in a cool, dark and dry place.

–

Never expose the batteries to temperatures below -10°C (14°F) or above 45°C (113°F).

–

Over the course of time, batteries lose their charging capacity and require a recharging period. If the bat-

tery performance drops considerably, then it is time to replace the battery.

–

New batteries are supplied only in partial charged condition. Some batteries only achieve their full capaci-

ty after several complete charge and discharge cycles.

–

When disposing of disused batteries, observe the valid legal and municipal regulations.

Never dispose of batteries in fire as they can leak or explode!

Assembly and set up

M400020-210322-Rev007-UM-e