Aussie Pumps QP Instrukcja instalacji, obsługi i konserwacji - Strona 7

Przeglądaj online lub pobierz pdf Instrukcja instalacji, obsługi i konserwacji dla Pompa wodna Aussie Pumps QP. Aussie Pumps QP 8 stron.

4. MAINTENANCE AND REPAIR

a. Disconnect spark plug wire while performing maintenance or repair

on the pump or engine.

b. Always replace safety devices removed during service or repair

before operating.

5. 12-VOLT ELECTRICAL SYSTEM

a. Connect negative battery lead to ground to prevent damage to

charging system.

b. To prevent arcing, when removing battery, disconnect negative lead

first. When replacing battery, connect negative lead last.

c. Do not spill battery acid. If spilled, rinse off immediately with water.

6. DIESEL

Follow engine manufacturer instructions explicitly on hand cranking.

7. OVERHEATING – DO NOT RUN THE PUMP FOR OVER TEN MINUTES

WITHOUT WATER FLOWING THROUGH IT!

Overheating pumps can cause severe burns and injury. If overheating

of pump casing occurs:

a. Stop the pump immediately.

b. Allow the pump to cool completely.

c. Slowly and cautiously vent the pump.

C. ELECTRIC MOTOR POWERED PUMPS

1. GROUND FAULT CIRCUIT INTERRUPTER

Never operate a pump with a plug-in type power cord without a ground

fault circuit interrupter.

2. WET HANDS

Never handle energized power cords with wet hands.

3. WATER

Never let extension cords or the plug connection lay in water. Locate

the pump such that it cannot fall into the water (except when using the

Submersible pumps.)

4. EQUIPMENT

Never use cords with frayed or cut or brittle insulation. Check the cord

on the pump for nicks in the insulation and for sound connections to

the ground fault interrupter plug and motor.

Any wiring to be done on pumps should be done by a qualified

electrician.

Page

document number: QPWP151204

Australian Pump Industries