Aussie Pumps D1310P4 Instrukcja obsługi i konserwacji - Strona 13

Przeglądaj online lub pobierz pdf Instrukcja obsługi i konserwacji dla Myjka ciśnieniowa Aussie Pumps D1310P4. Aussie Pumps D1310P4 20 stron. Hot water pressure washer

Drukuj stronę

REGULATING PRESSURE.

This chapter concerns only

those models provided with

the "pressure regulating" de-

vice. The pressure regulator,

fig. 10, allows the operator to

adjust the working pressure.

When knob C is turned

an anti-clockwise direction

(B) (minimum), the working

pressure is reduced.

Use the steam nozzle (supplied as an accessory).

Turn the thermostat knob "B" (fig. 8) to steam position to obtain

an increase in the temperature of the water at delivery.

At work temperatures higher than 95°C (203°F), the work

pressure must be < 32 bar (460 PSI).

Danger

During use with boiling water, "Steam Phase", keep away

from the openings for fumes discharge (risk of burning).

When you have finished using the "Steam Phase", turn the

thermostat knob "B" to position "0" (fig. 8) and let the ma-

chine cool down for about 3 minutes with the gun turned on.

FIG. 10

MAINTENANCE

ONLY THE OPERATIONS AUTHORIZED IN THIS

INSTRUCTION MANUAL MAY BE CARRIED OUT BY

ALL OTHER OPERATIONS ARE FORBIDDEN.

Danger

For maintenance of the boiler, high pressure pump, the electrical

parts and all parts with a safety function, you must apply to our

Technical service centre.

The manufacturer is not liable in case of tampering, changes, in-

correct repairs or maintenance carried out on the machine by a

third person not provided with the manufacturer's authorization.

All documents pertaining to the repair and planned service

interventions, as well as any certificates concerning the device

installation according to the laws in force (in compliance with the

provisions of the IEC 60364-1 standard) must be kept carefully

by the user, together with the Instructions Manual.

Periodically, at least once a year, have the safety devices and

the rated values checked at one of our technical service centres.

Particularly, as for the hot water high pressure cleaner, which is

factory set, the exhaust system must be checked.

The rating done by the manufacturer determines a production of

exhaust gases with a CO content lower than 0,04% and a smoke

content corresponding to a smoke point nr.2 Shell-Bacharach

according to the laws in force.

Danger

Disconnect the water cleaner from the mains electricity supply

via the omnipolar switch or by unplugging the plug from the

socket and close the water supply tap (see chapters on connec-

ting to the electricity and water

maintenance jobs. Once maintenance has been completed,

ensure that the closing panels have been correctly reassembled

and anchored with the screws provided before reconnecting the

cleaner to the mains.

Failure to do so may cause a risk of electric shock.

THE USER.

mains) before carrying out any