ADE M703600 Instrukcja obsługi - Strona 3

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wagi ADE M703600. ADE M703600 12 stron. Electronic lifter scales

Drukuj stronę

This symbol means: "Consult operating instructions". To achieve accurate results,

read the instructions for use carefully before use and follow all instructions provided

therein. Keep the instructions for use for future reference.

Before weighing

Your ADE scale is a quality product. Before weighing please read this manual thoroughly and strictly

follow the instruction. Keep it properly for future use.

Safety Guide

For utmost performance and precise measurement, please follow carefully operation and

maintenance instructions herein mentioned.

Do NOT overload the scale. This will damage the load cell and automatically invalidate the warranty.

Do NOT keep any load on the scale for longer than necessary. This will decrease the scale's accuracy

and shorten the load cell's lifetime.

Before using the scale make shackle and hook are connected properly.

Once the power supply is running low please change batteries.

Do NOT use the scale under weather conditions which may influence the weight results by electronic

interference.

Do NOT open the scale. In case of any default contact your local representative.

Make sure no water or cleaning fluid is penetrating the scale.

Check carton contents

Electronic Lifter Scale

2 Safety hooks (1 shackle link, 1 stable S-hook)

3 x AA Batteries

Operating Manual

Insert batteries

Open the battery compartment on the backside of the scale by sliding the lid aside.

Insert 3 x AA Batteries respecting the pole markings.

Shut the battery compartment carefully and make sure it is completely closed.

In case display shows 'LO' batteries are flat and need to be replaced.

Installation of scale to a suitable person lifter

Insert the shackle link into the upper the S-hook into the lower suspension of the scale.

Remove the suspension yoke of the person lifter and replace this by using the upper suspension

eye of the scale to combine lifting arm and scale.

Slide the suspension respectively the carrying equipment of the person lifter carefully into the S-

hook.

Weighing

To achieve a reliable result make sure the scale in always in vertical position. The S-hook must not yet

be loaded by any weight. Press the ON key to start the scale. After a short function test the display

becomes stable, the scale has found its zero point and shows '0.00' kg.

M703600+M703600-01-210817-Rev008-UM-en