Datavideo TLM-170G Instrukcja obsługi - Strona 11

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Monitor Datavideo TLM-170G. Datavideo TLM-170G 16 stron. 17.3" 3g-sdi tft lcd monitor
Również dla Datavideo TLM-170G: Skrócona instrukcja obsługi (13 strony), Skrócona instrukcja obsługi (16 strony)

Drukuj stronę

Firmware update procedure

From time to time Datavideo may release new firmware to either add new features or fix

reported bugs in the current TLM-170G firmware. Customers can update the DAC-70 firmware

themselves or contact their local dealer for assistance.

This page describes the firmware update process and it should take approximately 15 minutes

of total time to complete.

A working TLM-170G requires the following:

• The latest firmware file for the TLM-170G monitor. This can be obtained from your local

Datavideo office or dealer.

• A USB 2.0 pen drive (128MB or larger) with a USB A connector.

Once started the update process should not be interrupted in any way as this could result in

a non-responsive unit.

How to update the Scaler firmware

1. Unzip / extract the supplied zipped archive or rar file.

2. Erase the contents of the USB 2.0 pen drive.

3. Transfer / copy the unzipped / extracted file to the USB 2.0 pen drive.

4. Plug the USB 2.0 pen drive into the USB 2.0 port labelled MAINTENANCE located on the

rear panel of the TLM-170G monitor.

5. Power on the monitor and press the MENU button to display the OSD Main Menu.

6. Use the OSD Menu buttons [UP, DOWN & ENTER] to select the SETUP F.W. option.

7. Use the OSD Menu buttons [UP, DOWN & ENTER] to select UPDATE SCALER F.W.

8. The TLM-170G tally light will flash different colours whilst the update is in progress.

9. The TLM-170G monitor reboots itself at the end of the process.

How to update the FPGA firmware