4qd PRO-160-HV Instrukcja obsługi - Strona 2

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Kontroler 4qd PRO-160-HV. 4qd PRO-160-HV 16 stron.
Również dla 4qd PRO-160-HV: Instrukcja obsługi (16 strony)

Drukuj stronę

Introduction

The Pro-160 is an advanced digital PWM motor controller for currents up to 200A.

It uses a specialist microprocessor to control a full H-bridge design that does not

require relays for reversing. The display provides key information to the operator,

and can be mounted separately to the controller if required. It has a full range of

features and is very easy to configure if required.

Do's and Don'ts

Warning – the Pro-160 does not have reverse polarity protection.

Connecting the battery wires incorrectly WILL destroy the controller.



Do read the instructions fully

before installing.



Do take care to connect the

battery wires with the correct

polarity



Do fit a motor suppression

capacitor, and ferrite rings.



Do twist the motor wires

together if possible.



Do call 4QD if you are

uncertain about something

Getting Started



First remove the four screws that hold the cover to the end plates and lift off

the cover.



The Pro-160 is supplied with the keymat ribbon cable not connected to its

socket. We recommend only plugging this in once the Pro-160 has been

fixed in position, the control and power connections made, and you are

ready to start operation.

PRO-160 V2.0 10/19

Do not



Do not allow water to enter

the box.

Page 2