4qd PRO-160-HV Instrukcja obsługi - Strona 5
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Kontroler 4qd PRO-160-HV. 4qd PRO-160-HV 16 stron.
Również dla 4qd PRO-160-HV: Instrukcja obsługi (16 strony)
Drukuj stronę7.
Thermistor input
Can be used to connect 1 or 2 sensors to monitor external temperatures.
Sensor X is connected to C and D, Sensor Y to A and B.
Once the sensors have been installed they must be enabled in the profile menu.
8.
Radio Control Input and BEC
The Pro-160 will accept a standard hobbyist radio control servo signal directly
from a receiver. The receiver should be connected to pins B, C, and D. Pin D is
linked to pin A by Lk1, this can be removed if a 4 wire radio connection is
required.
The Pro-160 is pre-programmed to work with the majority of radio receivers.
Profiles 7 and 8 are configured for RC single ended and RC joystick use.
Depending on your radio system you may need to use the RC learn function to
properly match the Pro-160 to your receiver output.
PRO-160 V2.3/2 04/20
Sensors X and Y should be 4QD
part number SEN-TMP.
Page 5
www.4qd.co.uk