Agri-Fab 190-368B Instrukcja obsługi - Strona 4
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wózek zewnętrzny Agri-Fab 190-368B. Agri-Fab 190-368B 12 stron. Utility carts
Drukuj stronę
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED FOR ASSEMBLY
(1)
Screwdriver
(1)
Pliers
(2)
7/16" Wrenches
(2)
1/2" Wrench
(2)
9/16" Wrenches
1. Remove the hardware pack and all loose parts
from the carton.
before discarding.
2. Lay out all parts as shown in the carton contents.
DO NOT LEAVE THE CART UNATTENDED IN
UPRIGHT POSITION DURING ASSEMBLY. A
FALLING CART CAN CAUSE PERSONAL INJURY!
PAY CLOSE ATTENTION TO THE STABILITY OF
THE CART WHILE IT REMAINS IN AN UPRIGHT
POSITION. FOR BEST STABILITY, ASSEMBLE
ON A SMOOTH, LEVEL SURFACE.
3. Position cart body halves upright on a smooth
level surface such as a garage floor or a paved
driveway. See figure 2.
4. Assemble halves together using three 1/4" x 1/2"
hex bolts and 1/4" hex nuts as shown in figure 2.
Do not tighten.
FIGURE 2
Be sure the carton is empty
CAUTION
1/4" x 1/2" HEX BOLT
1/4" HEX NUT
5. Position the tailgate reinforcement bracket on
outside of cart as shown in figure 3. Assemble to
the bottom of the cart body using four 5/16" x 3/4"
truss head bolts and 5/16" hex nuts. Do not
tighten. See figure 3.
6. Position the tailgate guides on the inside of the
cart bodies with guide channels to the front as
shown in figure 3. Assemble using four 1/4" x 1/2"
hex bolts and 1/4" hex nuts. Do not tighten.
5/16" HEX NUT
FIGURE 3
7. At this time, with the cart body halves pulled
together, tighten the four truss head bolts as-
sembled in step 5 and then tighten the four hex
bolts assembled in step 6. Do not tighten the
three hex bolts that were assembled in step 4.
8. Carefully reverse the position of the cart so that it
rests on the tailgate reinforcement bracket, as shown
in figure 4.
FIGURE 4
4
1/4" HEX NUT
TAILGATE GUIDE
1/4" x 1/2"
HEX BOLT
5/16" x 3/4"
TRUSS HEAD BOLT
TAILGATE
REINFORCEMENT
BRACKET