Australian Direct ADCHG128 Podręcznik użytkownika - Strona 6
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Ładowarka Australian Direct ADCHG128. Australian Direct ADCHG128 12 stron. Smart battery charger 12v 8a, suitable for 12v normal lead acid, sealed, agm or gel batteries between 10-150ah, ip65
Drukuj stronęShort-circuit protection
Should you accidentally touch the alligator clips together whilst the mains power is on, the unit will not perform
charging. Unplug from mains, disconnect and start the process again being careful not to touch the clips
together.
Charge memory
If power is off on charging, AD Battery Charger can automatically restart charging based on previous power
down status for battery and charging current.
ATTENTION: Once the clamp of charger is disconnected from the battery, this memory is erased and the
charging mode will need to be reselected.
Other features
Anti Spark Protection
Battery and Charger Overheating Protection
Integrated Warning Buzzer
Water Resistant Plastic Housing. Ingress Protection Rating IP65
OPERATION
PLEASE READ CAREFULLY BEFORE USING
Suitable for 12V Normal Lead Acid, Sealed, AGM or Gel Batteries between 10-150Ah
1. Preparing the battery
Ensure the battery terminals are clean and free of dirt so a good connection can be made.
WET / Flooded Lead Acid Batteries
Firstly remove the caps from each cell and check that the level of the liquid is sufficient in each cell. If it is below
the recommended level, top up with de-ionized or distilled water.
Note: Under no circumstances should tap water be used. The cell caps should not be replaced until charging is
complete. This allows any gases formed during charging to escape. It is inevitable that some minor escape of
acid will occur during charging.
AGM / Sealed Batteries
As AGM batteries are fully sealed there is no need to check fluid levels, just ensure the battery connections are
clean and the battery is in a suitable condition for charging.
2. Connection
2.1 Connecting to a Battery out of a vehicle.
Connect the RED Output Lead
(Battery Clip from the charger to the Positive (+) Battery Terminal)
and ensure a good connection is made.
Connect the BLACK Output lead
(Battery Clip from the charger to the Negative (-) Battery Terminal)
and ensure a good connection is made.
BLACK
RED
Alternatively if connecting via the Chargers Output Anderson style
connector, make sure the external plugs polarity is correct
before connecting.
Connection out of vehicle