AUSTRALIAN MADE GREAT MATE Instrukcje instalacji i konfiguracji - Strona 20

Przeglądaj online lub pobierz pdf Instrukcje instalacji i konfiguracji dla Silnik AUSTRALIAN MADE GREAT MATE. AUSTRALIAN MADE GREAT MATE 20 stron. Double swing gate motor kit

Drukuj stronę

1. A regular cleaning to remove dust & dirt. A small soft brush will suffice.

2. Approximately every 6 months remove the motor cover, clean with a soft brush and spray

inside the motor cover. Spray with a surface spray suitable for crawling insects, slugs and

snails. DO NOT SPRAY ANY ELECTRONIC COMPONENTS.

3. Check Battery terminals for corrosion. If present, bushing with a wire brush or dipping the

actual terminals – 'hot water' will remove it. A light spray with WD40 will help keep them

clean.

4. Using a small screwdriver, tighten all terminal block screws and ensure any cables are no

t frayed at the ends.

5. Ensure Receiver is firmly mounted.

6. Tighten all mounting and attachment bolts.

7. Check screws on Push Button covers are intact and tight.

8. If Photocells (Sensors) are fitted, remove covers and gently brush any cobwebs, etc. away.

Check operation and replace.

Finally, there is usually no substitute for good housekeeping. Ensuring the Motors and the

area around the Motors and Gates are free of rubbish, leaves, infestation of insects and

trimming of plants will help to give a long and trouble-free life.

Should you be unsure of any points above, PLEASE contact us.

AUSTRALIAN MADE GREAT MATE Instrukcje instalacji i konfiguracji - Strona 20

Maintenance