Agri-Fab SUPER 17 Instrukcja obsługi - Strona 6
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wózek zewnętrzny Agri-Fab SUPER 17. Agri-Fab SUPER 17 12 stron. Atv cart
Również dla Agri-Fab SUPER 17: Instrukcja obsługi (12 strony)
Drukuj stronę
14. To prevent accidental tipping during the following
assembly procedures, lower the cart to rest upside
down on its top flanges, so that the wheel support
is facing up. See figure 8.
15. Assemble both axle brackets to the wheel support
using eight 5/16" x 3/4" hex bolts and 5/16" nylock
nuts. Place the welded tubes to the inside. See
figure 8.
AXLE BRACKETS
(PLACE WELDED TUBES
TO INSIDE AS SHOWN)
5/16" NYLOCK NUT
5/16" x 3/4"
HEX BOLT
FIGURE 8
16. Place the tongue, open side facing up, onto the wheel
support and the latch stand bracket. See figure 10.
17. Place a long spacer tube on each side of the tongue
and assemble the axle through the wheel support,
the two spacer tubes and the tongue. Secure the axle
using two 1/4" x 1-3/4" hex bolts and 1/4" nylock nuts.
Tighten. See figure 9.
LONG SPACER TUBES
1/4" x 1-3/4"
HEX BOLT
AXLE
BRACKET
1/4" NYLOCK NUT
FIGURE 9
18. Place the latch lock lever through the slot in the
WHEEL
SUPPORT
FIGURE 10
19. Hook the short end of the spring into the hole in the
AXLE
TONGUE
LATCH STAND
BRACKET
FIGURE 11
6
tongue as shown in figure 10. Assemble the 5/16" x
3-3/4" hex bolt through the tongue, the lever and two
5/16" nylock nuts (one on each side of the lever).
Assemble a 5/16" nylock nut onto the end of the bolt
so that the bolt has no end play, but can rotate freely.
Tighten the two 5/16" nylock nuts against the sides
of the latch lock lever so that the lever is centered in
the slot. See figure 10.
5/16" x 3-3/4"
HEX BOLT
latch lock lever. Use the spring puller tool to hook the
long end of the spring into the square hole in the
tongue. The spring puller tool can be stored when
finished. See figure 11.
SPRING PULLER TOOL
5/16" NYLOCK NUTS
LATCH
LOCK
LEVER
5/16"
NYLOCK
NUT
LONG END
OF SPRING
LATCH LOCK LEVER