4SeasonSpa Augusta 20 Podręcznik użytkownika - Strona 6
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Wanna z hydromasażem 4SeasonSpa Augusta 20. 4SeasonSpa Augusta 20 12 stron. Easymini control box
Drukuj stronę2 Water filtration & Temperature
FDx: duration of the filter cycles, FSx: time to start the filter cycle for the first time
• FD – duration of the filter cycle
The duration of the filter cycles can be set from 0 hours (filtering
disabled) to 12 hours (continuous filtering) with 1 hour steps. We
recommend 2 or 3 hours each cycle.
2.2.2
Filter cycles for spa's with extra circulation pump
In this configuration your spa is equipped with a 24-hour circulation pump, running all day long. To have more water movement in the spa and to clean
all hoses from the inside the spa control will start a PURGE cycles a few times a day. During each purge cycle the jet pump is running for 40 seconds
on high speed. By pressing the
6 (recommended) the spa will have each 4 hours 1 purge cycles of 40 seconds (24 hour/6=4).
Filter Boost function
This function is used to activate an accelerated filter cycle of limited duration. Pump 1 is started at high speed, and the ozone generator runs for
45 minutes. To activate the function, press and hold the
and/or addition of chemical products. The display shows the code BOO.
2.3
Water Temperature
• The display shows the current water temperature.
• By using the arrow buttons
be shown on the display for five seconds, confirming the new settings, display shows
be shown on the display for five seconds, confirming the new settings, display shows
be shown on the display for five seconds, confirming the new settings, display shows
be shown on the display for five seconds, confirming the new settings, display shows
temperature.
• The water will be re-heated when the temperature has dropped 0.5 degrees Celsius.
The water temperature can be set at a value between 15 and 40 °C.
6
button and the
and
button for 5 seconds. This function has to be activated after intensive use of the SPA
and
you can adjust the water temperature to the desired level. The newly selected water temperature will
• FS – start up time to start the filter cycle
Now you can enter time when you wish to start the first filter cycles.
After that the filter cycles will start with an interval of 12 hours.
buttons the purge cycle can be controlled and adjusted. When you enter a purge of
. After 5 seconds the display will again show the current
. After 5 seconds the display will again show the current
. After 5 seconds the display will again show the current
. After 5 seconds the display will again show the current