AUSTRAMAC FLASHCUT 1400 RM Instrukcja obsługi - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Piła AUSTRAMAC FLASHCUT 1400 RM. AUSTRAMAC FLASHCUT 1400 RM 14 stron. Diamond rock saw

Transportation Guidelines:

1. Only approved AUSTRAMAC stand to be used to store rock saw.

2. Use lifting equipment to load rock saw. Ensure lifting equipment is

capable of taking the load of the machine as indicated on rock saw

identification stamp.

3. Strap rock saw to stand with approved strap supplied by

AUSTRAMAC or another strap capable of taking the load.

4. Ensure quick hitch is secure when lifting with excavator and pin

inserted where appropriate.

5. Lift rock saw and position with lifting equipment or excavator on to

transport vehicle.

6. Ensure rock saw is carefully placed on stand and does not contact

ground etc. take care with blade.

7. Attach rock saw with chains or straps capable of holding the load.

8. Ensure that transport vehicle is capable of taking load of rock saw

and stand an indicated-on rock saw identification badge.

9. Unlock rock saw and stand following above procedures in reverse.

10. Carefully place rock saw and stand on secure level ground.

Installation and Commissioning

The rock saw comes with all parts assembled ready for use. Operators

should consult AUSTRAMAC prior to completing any service,

repair or modifications. It is essential that the rock saw is securely

attached to the excavator at all times to prevent serious injury to operators

or others and damage to the machine. Operators must attach the rock saw

as indicated below and perform a "Prestart Check" on the machine prior

to use (a sample prestart check has been provided at the end of this

manual).