Agri-Fab 26" Leaf/Lawnsweeper 45-02181 Instrukcja obsługi - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Zamiatarka do trawników Agri-Fab 26" Leaf/Lawnsweeper 45-02181. Agri-Fab 26" Leaf/Lawnsweeper 45-02181 12 stron. 26'' leaf/lawnsweeper
Również dla Agri-Fab 26" Leaf/Lawnsweeper 45-02181: Instrukcja obsługi (13 strony)

Drukuj stronę

For Agri Fab Discount Parts Call 606-678-9623 or 606-561-4983

CAuTIoN: EYE PRoTECTIoN SHouLD BE

WoRN WHILE oPERATING SWEEPER

DuMPING oF SWEEPER

To dump sweeper hopper bag, simply tip the sweeper forward

or lift off the complete hopper bag frame.

Always dump hopper after each use. Damp or wet grass

and leaves will cause damage to hopper if stored for long

periods of time.

CAuTIoN: Do NoT DuMP THE SWEEPER

Too CLoSE To A FIRE AS THE BRuSHES

AND BAG CAN BE DESTRoYED BY

EXCESSIVE HEAT oR FLAME.

SToRAGE

The entire unit may be hung on a wall or the hopper bag

frame can be removed for storage.

LuBRICATIoN/MAINTENANCE

The bearings in the sweeper have been prelubricated at

the factory. It is recommended that a few drops of light

oil be added to the brush shaft bearings twice a year.

The wheels should be removed to clean gears every two

years. After cleaning, apply an even coat of light grease.

See figures 11, 12 and 13.

NoTE:

To remove the wheel, pop off hub cap with a screw

driver and remove retaining "E" ring and flat washer.

FIGuRE 11

WHEEL GEARS/PAWL SERVICE

IMPoRTANT: Do not remove both wheels at the same

time to avoid mixing parts. (The R.H. and L.H. ratchet

gears are not interchangeable.) Make notes on the position

of washers and snap rings during disassembly.

1. Remove only one wheel from the sweeper.

2. Remove the retaining rings and washers which hold

3. Remove the gear by sliding it off the brush shaft. (Look

4. To reassemble, insert the drive pin through the hole

5. Lightly grease the shaft and fill the ratchet gear with

6. Lightly grease the axle and the gear teeth on the

7. Remove opposite wheel and repeat steps 1-6 for that

FIGuRE 12

www.mymowerparts.com

the ratchet gear onto the brush shaft.

for the drive pin, which may fall out of the brush shaft

when the ratchet gear is removed.

near the end of the brush shaft. Make sure the pin

slides back and forth easily in the shaft.

grease. Assemble the ratchet gear back onto the shaft.

wheel and then reassemble the wheel. The brushes

should rotate only during forward movement. If the

brushes rotate by both forward and reverse movement,

the drive pin is jamming in the ratchet gear. Dissamble,

clean and lubricate the drive pin and ratchet gear and

then reassmble wheel.

wheel.