Bresser Meteo THBM Colour Instrukcja obsługi - Strona 8
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Stacja pogodowa Bresser Meteo THBM Colour. Bresser Meteo THBM Colour 20 stron.
Drukuj stronę
3 Humidity value (outdoor)
5 Dew point
7 Barometric pressure (hPa, inHg or mmHg)
9 Moon phase
11 Humidity trend (indoor) (rising, steady or fall-
ing)
13 Climate indicator (indoor) (too cold, optimal,
too warm)
15 Alarm symbol for high (HIGH) or low (LOW)
humidity
17 Temperature unit (°C or °F selectable)
19 Daylight saving time (DST)
21 Alarm symbol for high (HIGH) or low (LOW)
temperature (indoor)
23 Battery level indicator
25 Current time (seconds)
27 Current time (minutes)
29 Weekday
31 Alarm symbol for high (HIGH) or low (LOW)
temperature (outdoor)
33 Temperature trend (outdoor) (rising, steady or
falling)
35 Alarm symbol for high (HIGH) or low (LOW)
humidity (outdoor)
7 Before starting operation
NOTICE
Avoid connectivity disruptions!
To avoid connectivity disruptions between the devices, consider the following points before starting
operation.
1. Place base station (receiver) and remote sensor (sender) together as close as possible.
2. Set up power supply for the base station and wait until the indoor temperature is displayed.
3. Set up power supply for the remote sensor.
4. Position the base station and the remote sensor within the effective transmission range.
5. Ensure that the base station and remote sensor are assigned to the same channel.
When changing batteries always change batteries in the main unit as well as all remote units and re-
place them in the correct order, so the remote connection can be re-established. If either of the
devices is mains-powered, the power supply must be disconnected for a short moment also for this
device when exchanging the batteries. If batteries are exchanged in only one of the devices (i.e. the
remote sensor) the signal can't be received or can't be received correctly.
Note, that the effective range is vastly affected by building materials and position of the main and re-
mote units. Due to external influences (various RC devices and other sources of interference), the
maximum distance can be greatly reduced. In such cases we suggest to position the main unit and the
remote sensor at other places. Sometimes all it takes is a relocation of one of these components of a
few inches! Though the remote unit is weather proof, it should be placed away from direct sunlight,
rain or snow.
8 / 20
4 Climate indicator (outdoor) (too cold, optimal,
too warm)
6 Heat index
8 Graphical weather trend display
10 Symbol for highest (MAX) or lowest (MIN)
value
12 Indoor humidity value
14 Symbol indoor area
16 Temperature value (indoor)
18 Temperature trend (indoor) (rising, steady or
falling)
20 Alarm symbol (bell)
22 Symbol for radio signal
24 Month (M)
26 Day (D)
28 Current time (hours)
30 AM/PM information in 12-hour time mode
32 Temperature value (outdoor)
34 Ice warning
36 Symbol outdoor area with channel display