BENDIX MC-11 TRACTOR ANTILOCK Podręcznik - Strona 5
Przeglądaj online lub pobierz pdf Podręcznik dla Części samochodowe BENDIX MC-11 TRACTOR ANTILOCK. BENDIX MC-11 TRACTOR ANTILOCK 20 stron. Tractor antilock
Drukuj stronę
INLET SOLENOID
RESERVOIR
FIGURE 5 - EXHAUSTING: NORMAL SERVICE APPLICATION
1. Remove any accumulated contaminants and visually
inspect the exterior of the unit for excessive corrosion or
physical damage.
2. Inspect all air lines and wiring connected to the MC-11
tractor antilock assembly for signs of wear or physical
damage. Replace as necessary.
3. Perform "LEAKAGE TEST."
EVERY YEAR; 100,000 MILES; OR 3,600 OPERATING
HOURS
1. Perform "OPERATIONAL AND LEAKAGE TESTS."
OPERATIONAL AND LEAKAGE TESTS
LEAKAGE TEST
1. Park the vehicle on a level surface and block the wheels.
Release the parking brakes and build the air system to
full pressure.
2. Turn the engine OFF and make 4 or 5 brake applications.
Note that the service brakes apply and release promptly.
3. Build system pressure to governor cut-out and turn engine
OFF.
4. Make and hold a full service brake application.
A. Apply a soap solution to the relay valve exhaust port.
A 1" bubble in 3 seconds is permitted.
B. Apply a soap solution to the outside of the modulator
body where the relay valve joins the solenoid
assembly. A 1" bubble in 3 seconds is permitted.
EXHAUST
SOLENOID
SUPPLY
BRAKE
VALVE
CONTROL
PISTON
DELIVERY
EXHAUST
5. If leakage is excessive around the supply and exhaust
solenoids, replace the M-12
OPERATIONAL TEST
™
LED Operation
Although the MC-11
the LEDs (Light Emitting Diodes) should be inspected to
ensure that they are functioning properly. With the vehicle
ignition on, hold a magnet (capable of picking up 3 ounces)
to the RESET position on the diagnostic window. All LEDs
should illuminate. If one or more of the LEDs do not
illuminate, and the dash light indicates proper system
function, note the nonilluminated LEDs for future reference.
Diagnostic capabilities will be limited, but the system will
continue to function as designed.
Solenoid Operation
The MC-11
assembly monitors the system electronics upon
™
vehicle start-up. However, the vehicle should be tested to
verify proper solenoid function. Two technicians will be
required to properly test the solenoids.
1. Park the vehicle on a level surface and block the wheels.
Release the parking brakes and build the air system to
full pressure.
2. Turn the engine ignition key to the OFF position. Then
make and hold a full brake application.
DOUBLE
CHECK VALVE
TRAILER
CONTROL
VALVE
BRAKE
CHAMBER
modulator.
™
assembly has self-check diagnostics,
™
5