Airwell RC7 Instrukcja obsługi - Strona 9
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Pilot zdalnego sterowania Airwell RC7. Airwell RC7 10 stron.
Drukuj stronę
OPERATION
OPERATION
3. Press the + or - (HOUR) button until the
desired value is displayed.
4. Press the SET button to activate the timer.
C) HOW TO SET A PROGRAM FOR DAILY ON/
OFF OPERATION
1.
Press the TIMER button to select the desired
timer.
2. Press the SET button till the ON sign blinks.
3. Press the + or - (HOUR) button until the
desired value is displayed.
4. Press the SET button again, the OFF sign
blinks.
5. Press the + or - (HOUR) button until the
desired value is displayed.
6. Press the SET button to activate the timer.
D) HOW TO CLEAR THE TIMER
1. Press the TIMER button to select the timer.
2. Press the CLEAR button if you want that every
timer operation will be cleared.
NOTE
If the procedure to set the timer is not
completed, by pushing the SET button,
within 15 seconds the timer operation will be
cancelled and the last set-up is restored.
ADJUSTING THE AIR FLOW DIRECTION
HORIZONTAL (manual)
The horizontal air flow can be adjusted by moving
the vertical vanes to the left or right.
VERTICAL (with remote control unit)
The remote control gives you the possibility to
control the flap in two way:
1. Push the
button to start the flap sweep. If
you push again the flap stops immediately.
2. push the
button to move the flap step by
step. Or activate the horizontal air flow option
is selectable via switch.
Set vertical vanes to the front position during
COOLING/DRY operation if humidity is high.
If the vertical vanes are set to the left-most
or right-most position, condensation will form
around the air outlet and drip off.
Do not move the flap with your hands when the
air conditioner is running.
NOTES
The flap automatically closes when the unit is
off.
During the heating operation, the fan speed
will be very low and the flap will be in the
horizontal position until the air being blown
out of the unit begins to warm. Once the air
warms up, the flap position and fan speed
change to the settings specified with the
remote control.
8