dymax ACCU-CAL 160 Podręcznik użytkownika - Strona 12

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Przyrządy pomiarowe dymax ACCU-CAL 160. dymax ACCU-CAL 160 19 stron. Radiometer

ACCU-CAL™ 160 Radiometer User Guide

Once the unit has stopped taking measurements, the results are shown on the front display. If

the device was in the text mode (Figure 5), the dose and peak irradiance are shown, along with

the corresponding values of a reference measurement and the deviation to the reference. If

the device was in the graph mode (Figure 6), the irradiance profile and peak irradiance are

shown. To toggle between text and graph mode, press the left button. You may toggle

between the two modes without any loss of data.

The measurement data is stored in the device and shown on the display until a new

measurement is performed.

Perform a Reference Measurement

A reference measurement is a stored reading used to compare subsequent data readings to

identify if any changes have occurred. To perform a reference measurement, enter the setup,

move the arrow to the item "Start Reference Measurement", and press the right button. A

message "Start Reference Measurement" is shown. All further steps are similar to the normal

measurement and described in the previous section.

After the reference measurement, you can either save or discard the recorded values as

reference.

Figure 9. Setup Menu