AFF 3102 Instrukcja obsługi - Strona 2

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Walety AFF 3102. AFF 3102 12 stron. 1 ton 2 stage transmission jack

WARNING

The use of portable automotive lifting devices is subject to certain hazards that cannot be prevented

by mechanical means, but only by the use of care and common sense. It is essential to have qualified

personnel involved in the use and operation of this lifting equipment that have been trained and qualified in

its safe operation and proper use. Examples of hazards are dropping, tipping, or slipping of loads caused

primarily by improperly securing loads, overloading, off-centered loads, use on poor surfaces, and/or

using the equipment for a purpose for which it was not designed.

It is the responsibility of the owner and operator to study and understand this product and follow the safety

instructions prior to operating this equipment. If the operator is not fluent in English the product and

safety instructions shall be read and discussed in the operator's native language by the purchaser, owner,

or his designee.

A copy of these instruction/warnings should be kept intact and located in a convenient location for future

reference. If the manual is lost or not readable contact American Forge & Foundry for a digital copy.

Methods to Avoid Hazardous Situations

• Read, understand, and follow all instructions before operating this device.

• Do not use jack beyond its rated capacity of 2,000 lbs.

• Do not use as a vehicle lifting device or as a vehicle support.

• Do not modify this product for any other purpose than that for which it was designed.

• Do not use any adapters unless approved or supplied by SureWerx USA.

• Wear eye protection that meets ANSI Z87.1.

• Inspect the jack before each use. Do not use if damaged, altered, modified, in poor condition,

leaking hydraulic fluid, or unstable due to loose or missing components. Make corrections

before using.

• Support the engine with a stand before unbolting the transmission from the engine.

• Consult the vehicle manufacturer for the transmission center of balance. Center load on saddle.

• Do not use a power tool to adjust the saddle tilt screws. Operate by hand or with a wrench.

• Use only on a hard level surface.

• Use of the product is limited to the removal, installation, and transportation in the lowered

position of transmissions, transfer cases, and transaxles.

• If any part of the equipment needs repaired or replaced please contact an AFF authorized repair

center.

• Failure to heed these warnings may result in serious or fatal personal injury and/or property

damage.

WARNING:

Read all instructions and safety warnings before

operating this equipment. Failure to follow the

instructions and safety warnings may result in

personal injury or property damage.

Page 2