GAC ESD-5570 Series Podręcznik - Strona 3
Przeglądaj online lub pobierz pdf Podręcznik dla Jednostka sterująca GAC ESD-5570 Series. GAC ESD-5570 Series 8 stron. Speed control unit
Również dla GAC ESD-5570 Series: Informacje techniczne (12 strony), Podręcznik (8 strony)
4
WIRINg (CONTINUED)
An overspeed shutdown device, independent of the governor system, must be provided to prevent loss of engine control
which may cause personal injury or equipment damage. Do not rely exclusively on the governor system to prevent over-
speed. A secondary shutoff device such as a fuel solenoid must be used.
When wiring eSD55XX Series controllers:
1.
Magnetic speed sensor wires connected to Terminals C and D MuST BE TWISTED AND/OR SHIELDED for their entire length. The
speed sensor cable shield should ideally be connected as shown. The shield should be insulated to ensure no other part of the shield
comes in contact with engine ground, otherwise stray speed signals may be introduced into the speed control unit.
2.
With the engine stopped, adjust the gap between the magnetic speed sensor and the ring gear teeth. The gap should not be any
smaller than 0.020 in. (0.45 mm). usually, backing out the speed sensor 1/4 to 1/2 turn after touching the ring gear teeth will achieve
a satisfactory air gap. The magnetic speed sensor voltage should be at least 1.0 V AC RMS during cranking.
3.
Use shielded cable for all external connections to the eSD controller.
4.
One end of each shield, including the speed sensor shield, should be grounded to a single point on the ESD case.
5.
Do not over-tighten terminals. Torque to no greater than 9.0 in-lb ±2.5 [1.01 ±0.28 N∙m].
3
ESD5550-5570 Series Speed Control Unit 1-2021-E1 PIB1003
Governors America Corp. © 2021 Copyright All Rights Reserved