GADLEE GT50 B50 Skrócona instrukcja obsługi - Strona 2
Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Scrubber GADLEE GT50 B50. GADLEE GT50 B50 2 stron.
Check the squeegee is clean and the
blades are not damaged.
Control Panel
Battery level
indicator
Hour counter
Lamp indicates when recovery
tank is full whilst vacuum fan is
automatically switched off.
REPLACING THE SQUEEGEE BLADES
release the clip;
remove the two blade retainers by pushing them towards the outside of the squeegee then
extracting them;
remove the blade;
reuse the same blade by reversing the edge in contact with the floor until all four edges are worn
out, or replace with a new blade, fitting it onto the screws on the body of the squeegee;
reposition the two blade retainers by centring the widest part of the slots over the fixing screws on
the squeegee body, then pushing the blade retainers inwards;
fasten the clip.
AUTOMATIC BRUSH ATTACHMENT
Attaching the brush: rest the brush on the floor in front of the machine and centre it with the guard. Lower the head and operate the
brush/drive lever repeatedly until the brush automatically engages on the flange hub. If the operation is not successful, repeat by pressing on
the lever again and repeating the centring.
Removing the brush: raise the machine head by pushing the head lift pedal down and then to the right and operate the brush/drive lever
repeatedly. After operating the lever a few times, the brush is released and falls to the ground.
TROUBLE SHOOTING
THE MACHINE DOES NOT COME ON/START UP
THE SUCTION MOTOR DOES NOT WORK
THE MACHINE LEAVES THE FLOOR WET
THE MACHINE LEAVES THE FLOOR DIRTY
THE MACHINE LEAVES STRIPES OF WET FLOOR
http://www.gadlee.com email: [email protected] Toll‐Free:4008‐833‐830
Check the battery charge.
CHECK THE BATTERY CHARGER
CHECK THE DIRTY WATER DRUM IS NOT FULL
CHECK THE DIRTY WATER DRUM LEVEL SENSOR IS NOT
BLOCKED/MALFUNCTIONING
CHECK THE SQUEEGEE BLADES ARE NOT WORN
CHECK THERE IS NO DEBRIS BETWEEN THE TWO SQUEEGEE BLADES
CHECK THERE IS NO DEBRIS IN THE SUCTION HOSE
CHECK THE SUCTION FILTER IS UNDAMAGED AND CLEAN
CHECK THE DETERGENT TANK LID IS CLOSED CORRECTLY
CHECK THE SUCTION HOSE IS CORRECTLY ATTACHED TO THE SQUEEGEE
CHECK THE TYPE OF BRUSH/PAD IN USE IS SUITABLE FOR THE TYPE OF DIRT AND
FLOOR.
CHECK THE FLOOR HAS BEEN BRUSHED BEFORE USING THE MACHINE
CHECK THERE IS NO DEBRIS BETWEEN THE TWO SQUEEGEE BLADES
CHECK THE SQUEEGEE BLADES ARE NOT WORN
CHECK THE SQUEEGEE IS CORRECTLY ADJUSTED
To charge, insert the battery charger
connector into the connector
alongside the squeegee lifting lever.
Key switch
Brush Switch
Lamp indicates solution reserve and
warns that there is around 30 seconds
solution left. Brush will stop automatic
after 30 seconds