Active Products ZE02 Podręcznik - Strona 16

Przeglądaj online lub pobierz pdf Podręcznik dla Myjka ciśnieniowa Active Products ZE02. Active Products ZE02 18 stron.

Drukuj stronę

TROUBLESHOOTING -

Problem

Cause

Garden hose

Loose fittings.

connection leaks.

Missing/worn rubber washer.

Spray wand, or

Spray nozzle not properly attached.

extension, or

nozzle leaks.

Broken o-ring or plastic insert.

Pump is noisy.

Pump is sucking air.

Water leaks from

Loose fittings.

pump (up to 10

Water seals are damaged or worn.

drops per minute

is permissible).

Oil Drip.

Oil seals are damaged or worn.

Motor buzzes

Supply voltage below minimum.

but fails to run.

System has residual pressure.

Voltage loss due to extension cord.

Pressure washer not used for long periods

IF YOU ENCOUNTER ANY ADDITIONAL DIFFICULTIES NOT LISTED, CALL CUSTOMER SERVICE

AT 1-866-924-7626 FOR ASSISTANCE.

CONTINUED

Solution

Tighten fittings.

Insert new washer.

Insert the spray nozzle into the trigger

gun. Carefully press in against the

spring tension and twist into the

locked position.

Call Customer Service.

Check that hoses and fittings are air

tight. Turn off machine and purge

pump by squeezing trigger gun until a

steady flow of water emerges through

the nozzle.

Check that all fittings are tight.

Call Customer Service.

Verify that only the pressure washer is

running on this circuit.

Turn unit "OFF", squeeze trigger on

spray want to release pressure, then

turn unit "ON".

Do not use extension cord with this

unit—plug directly into power outlet.

Call Customer Service.