GAE Optimizer EQX24 Instrukcja obsługi - Strona 9

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Sprzęt muzyczny GAE Optimizer EQX24. GAE Optimizer EQX24 14 stron.

• The POWER-LED

Should the LED fail to light when connected to the mains it is necessary to check the fuse, which

can be found on the inside of the device. Here it is necessary to open the device.

Important! Always disconnect the unit from the power supply before opening the enclosure!

Only replacement fuses of the same type should be used. Should the LED still fail to light after re-

placing the fuse then there is a failure to the device and the maintenance-free PTC-resistor is pro-

tecting from further damage.

All repair and service work should be carried out by authorised personnel only.

CONNECTIONS

• INPUT: One balanced XLR-input for each channel can be found on the rear panel of the GAE

EQX24. High quality input amplifiers ensure a minimum of distortion and a maximum of signal to

noise ratio.

• OUTPUT: Four outputs for the connection of the EQX24 with the power amplifiers can be found on

the rear panel of this device. The outputs are electronically balanced and are of low impedance. At

least 6...10 power amplifiers (depending on input impedance) can be connected to each channel

and frequency area without problem.

Please refer to "Hints on connection"! Polarity reversal, incorrect signal direction and faulty

cable material can cause serious damage to all connected equipment and loudspeakers!

is situated on the front panel and indicates the operational status of the unit.