Gage Bilt GB704 Oryginalna instrukcja obsługi - Strona 14
Przeglądaj online lub pobierz pdf Oryginalna instrukcja obsługi dla Narzędzia Gage Bilt GB704. Gage Bilt GB704 20 stron. Installation tool
Również dla Gage Bilt GB704: Instrukcja instalacji (13 strony), Podręcznik (14 strony)
Drukuj stronę
WARNING:
Disconnect tool from its power source before actuator removal or installation. Severe personal injury may occur if
power source is not disconnected.
CAUTION:
Actuator assembly-air (704130) can break if not careful.
CAUTION:
Do not over tighten actuator assembly-air (704130). Snug tighten only.
REMOVING ACTUATOR ASSEMBLY-AIR (704130)
1.
Remove actuator lever assembly (704343) including pin-slotted (400608) from handle assembly (704132).
2.
With actuator lever assembly (704343) removed, insert a 5/8" open end box wrench / adjustable wrench around actuator
assembly-air (704130).
3.
Loosen the actuator assembly-air (704130).
4.
Remove wrench. Unthread and remove the actuator assembly-air (704130) with fingers from the handle assembly (704132).
INSTALLING ACTUATOR ASSEMBLY-AIR (704130)
1.
Apply Teflon® tape onto threads of actuator assembly-air (704130) one to two wraps.
2.
Thread the actuator assembly-air (704130) all the way into handle assembly (704132) with fingers.
3.
Insert and turn 5/8" open end box wrench / adjustable wrench and snug tight approximately 1/4-1/2 turn.
4.
Re-attach the actuator lever assembly (704343) with pin-slotted (400608) to handle assembly (704132).
GB704 S/N: 3213 AND ABOVE
PLEASE CONTACT GAGE BILT FOR ALL OTHER SERIAL NUMBERS.
OVERHAUL
ACTUATOR ASSEMBLY-AIR
14
6/11 Rev. 5/22