Dyna-Glo Delux RMC-KFA65TDLX Podręcznik użytkownika - Strona 6

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Grzałka Dyna-Glo Delux RMC-KFA65TDLX. Dyna-Glo Delux RMC-KFA65TDLX 12 stron. Portable forced air heaters

Drukuj stronę

NEVER LEAVE THE HEATER

UNATTENDED WHILE BURNING!

8. LONG TERM STORAGE OF YOUR HEATER

FUEL TANK DRAIN

1. Remove Fuel Cap and Cap Fuel Filter(See Figure 10).

2. Drain Fuel Tank through Fuel Cap Opening and wash Fuel Cap Filter with clean fuel.

3.Using a small amount of kerosene,swirl and rinse the inside of the tank.

Never mix water with the kerosene as it will cause poor operation of the heater.

Pour the kerosene out making sure that you remove it all.

IMPORTANT : Do not store kerosene over summer months for use during next next heating season.

Using old fuel could damage heater.

4. Reinstall Fuel Cap Filter and Fuel Cap(See Figure 11).

IMPORTANT : Reinstall Fuel Cap Filter fully into Fuel Cap Opening on tank,

Otherwise it will not install completely.

Figure 10. Remove Fuel Cap and Filter

5.Store heater in dry well ventilated area. Make sure storage place is free of dust and corrosive fumes.

6.Store the heater in the original box with the original packing material and keep the USER'S MANUAL

with the heater.

Figure 11. Reinstall Fuel Cap Filter

NEVER LEAVE THE HEATER

UNATTENDED WHILE BURNING!

9. MAINTENANCE

WARNING!! : NEVER SERVICE HEATER WHILE IT IS PLUGGED IN OR

WHILE HOT!

USE ORIGINAL EQUIPMENT REPLACEMENT PARTS. Use of third party or

other alternate components will void warranty and may cause unsafe operating

conditions.

A.) FUEL TANK

FLUSH EVERY 200 HOURS OF

OPERATION OR AS NEEDED (SEE

STORAGE, PAGE 9)

B.) UPPER SHELL REMOVAL

-Remove Screw that secure Side Cover.

-Push out for arrow direction and extract Side

Cover's Bracket from Rectancle Hole and

Separate Side Cover(R).

-Side Cover(L) in opposite of Side Cover(R)

Separates by same method.

(RMC-KFA120T/170TDLX Models Only.)

-Remove 4 Screws along each side of heater

using medium phillips screwdriver. These

Screws attach Upper Rear and Lower shells

together. (See Figure 12)

(RMC-KFA65TDLX Model Only.)

-Remove Screws along each side of heater using

medium phillips screwdriver. These Screws

attach Upper and Lower shells together.

C.) AIR OUTPUT,AIR INTAKE AND

LINT FILTERS WASH AND DRY

WITH SOAP AND WATER OR

REPLACE EVERY 500 HOURS OF

OPERATION OR ONCE A YEAR.

-Remove Upper Shell.(See Figure 12)

-Remove Fan guard.(See Figure 13)

-Remove End Filter Cover Screws using

medium phillips screwdriver.

-Remove End Filter Cover.

-Replace Air Output and Lint Filters.

-Wash or Replace Air Intake Filter.

-Reinstall Fan Guard and Upper Shell.

Figure 12. Upper Shell Removal.

Figure 13. Air Output,Intake,and Lint Filters