Hi Sharp 3.5" Podręcznik użytkownika - Strona 5

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Monitor Hi Sharp 3.5". Hi Sharp 3.5" 8 stron. 3.5” lcd cctv test monitor

Type B. tester

3.PTZ control test：

a. Switch "MODE key" to get "RS485" page as below.

b. Push "MENU key" to entry detail Protocol Setup.

c. Make sure your remote device protocol is setup correctly at first then

configure this as the same.

For example, Protocol：PELCO P / ID：1 / Baud rate：9600

c. Control direction of PTZ camera by "direction key" and press "Up +

Right" key for Zoom in and press "Down + Left" key for Zoom out is

available that vision was shown on monitor presents communication is

correct.

4.Cable test：

Open or Short circuit test for 2 sets.

a. Switch "MODE key" to get "CABLE TEST" page.

b. Connect two end of termination with "Cable test terminal" to test circuit

status is OK(Short) or NG(Open) as below.

c. 2 testing channels are independently that make sure connect port is

pair at first.