Gage Bilt GB752 Informacje o narzędziu instalacyjnym - Strona 6
Przeglądaj online lub pobierz pdf Informacje o narzędziu instalacyjnym dla Narzędzia do nitów Gage Bilt GB752. Gage Bilt GB752 12 stron.
Również dla Gage Bilt GB752: Oryginalna instrukcja obsługi (20 strony), Informacje o narzędziu instalacyjnym (13 strony)
Drukuj stronę
DESCRIPTION
WARNING:
THE BALANCE OF THIS TOOL IS DESIGNED FOR HORIZONTAL USE AND IS NOT SUITED FOR
ANY OTHER APPLICATIONS. GAGE BILT WILL BE PLEASED TO ADVISE FOR YOUR SPECIFIC
APPLICATION.
The GB752 is a pneumatic-hydraulic tool designed specifically for the efficient installation of a wide range of blind
rivets. It weighs 4.75 lbs. and can be operated in any position with one hand. It has a .500" rivet setting stroke and
a rated pull load of 3800 pounds with 90 psi air pressure at the air inlet.
The GB752 riveter is designed to operate on a range of air pressure, with 90 to 100 psi providing the maximum
efficiency. At 90 psi air pressure, the GB752 does not exceed 81.5 db (A) and consumes 3.9 cfm at 20 cycles a
minute.
The air inlet is provided with 1/4-18 female pipe threads to accept the users air hose fitting.
NOSE ASSEMBLIES ARE NOT FURNISHED WITH TOOL AND MUST BE ORDERED SEPARATELY. (See page 8 for
nose assembly recommendations.)
MAINTENANCE
WARNING:
EXCESSIVE CONTACT WITH HYDRAULIC FLUID AND LUBRICANTS SHOULD BE AVOIDED.
WARNING:
MAINTENANCE PERSONNEL
The performance of any tool depends upon good maintenance practices. Following these minimal requirements
for service and care will extend the life of your tool.
*Only use an air supply set at 90-100 p.s.i. equipped with a filter-regulator to prevent wear.
*The tool will eventually lose some hydraulic oil. Keep the hydraulic system full (only use Dexron III, or equivalent)
and free of air by using the air bleeder (704153) on a weekly basis.
*Proper care by operator is necessary in maintaining full productivity and reducing downtime. Read all
applicable tool manuals and nose assembly data sheets prior to operating tools.
*Keep nose assemblies, especially jaws, clean and free of chips and debris. Lube jaws and collet surfaces that
jaws ride on with light machine oil on a daily basis.
*All Screwed End Caps, Base Covers, Air Fittings, Triggers, Screws and Nose Assemblies are to be examined at
the end of each working shift to check that they are secure.
*Check daily all Hoses, Couplings, and Tools for damage or air/hydraulic leaks. Tighten or replace (if necessary).
*For a complete overhaul, tool kit GB704TK is recommended. It includes items 46-52 (see page 8).
CLEANING AND LUBRICATING PROCEDURE
Daily cleaning and lubrication of nose assembly will greatly reduce
downtime and increase life of components. Using sewing machine
oil, or an equivalent cleaner/lubricant, follow instructions below.
1. Disconnect tool vacuum line (if equipped).
2. Point nose assembly into oil as shown (Fig. A).
3. Cycle tool 8-10 times and wipe dry.
TORQUE SPECIFICATIONS
Button Head Cap Screws (17) = 40 inch lbs.
Flexlock Nut (42) = 40 inch lbs.
Packing Plug (38) = 45 foot lbs.
End Cap (752313) = 45 foot lbs.
Button Head Cap Screws (402482) = 35-40 inch lbs. (Do NOT over-tighten)
MUST
READ AND UNDERSTAND ALL WARNINGS AND CAUTIONS.
6
Fig A.
REV. 4/13