Gage Bilt GB7624 Oryginalna instrukcja obsługi - Strona 11

Przeglądaj online lub pobierz pdf Oryginalna instrukcja obsługi dla Narzędzia do nitów Gage Bilt GB7624. Gage Bilt GB7624 20 stron. Hydraulic tool
Również dla Gage Bilt GB7624: Instalacje (9 strony)

Drukuj stronę

Providing all maintenance conditions have been met, follow this systematic approach to diagnosis.

1. NO OPERATION WHEN

a) Check Powerunit power source.

b) Control cord may be loose or damaged.

c) Faulty electric actuator. Replace.

d) Check hydraulic couplings; repair or replace.

2. SLOW OR PARTIAL OPERATION WHEN

a) Low hydraulic pressure. Check powerunit, adjust.

b) Piston o'ring (404521) on the piston assembly (762114) could be worn or damaged. Replace.

c) Excessive wear or scoring on moving parts. Check and replace faulty parts.

3. TOOL OPERATES IN REVERSE.

a) Tool stops in back position. Hydraulic hoses are reversed. Correct.

4. HYDRAULIC OIL OVERHEATS.

a) Powerunit motor rotation reversed. Electrical connections reversed. See powerunit instruction manual.

b) Restrictions in either hydraulic lines, hoses or couplings. Check and tighten, clean or replace. (See hydraulic thread preparation pg.10).

5. OIL LEAKAGE.

a) Hydraulic oil leaks from connections. Tighten threaded connections. (See hydraulic thread preparation pg.10).

b) Oil leaks from tool. Determine source of leak and replace worn or defective o'rings and back-up rings.

6. PINTAIL GROOVES STRIPPED DURING PULL STROKE.

a) Nose Assembly must be pushed onto fastener fully.

b) Chips may have collected in chuck jaws. Disassemble nose assembly, clean jaws in mineral spirits using a sharp pointed object.

c) Chuck jaws may be worn or damaged. Replace.

d) Pintail too short for jaws to properly grip. Select proper grip length fastener.

e) Excessive gap between sheets. Reduce gap before attempting to install fastener.

7. NOSE ASSEMBLY WON'T ACCEPT FASTENER PINTAIL.

a) Spent fastener stem may be jammed in pulling head. Disassemble and check for worn or broken parts in nose assembly.

Replace defective parts and clean before reassembling.

GB7624 S/N: 1140 AND ABOVE

PLEASE CONTACT GAGE BILT FOR ALL OTHER SERIAL NUMBERS.

TROUBLESHOOTING

ELECTRIC ACTUATOR (240122) / AIR ACTUATOR ASSEMBLY (240123)

IS DEPRESSED.

Rev. 4/22