GREAT ARBOR Thuraya XT-Hotspot Podręcznik użytkownika - Strona 7

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Router bezprzewodowy GREAT ARBOR Thuraya XT-Hotspot. GREAT ARBOR Thuraya XT-Hotspot 14 stron.

Drukuj stronę

Making the First Connection

tart by connecting the Thuraya XT Phone to the bundled USB hub via the Thuraya XT data USB

cable (not included in package). Connect the USB hub to the standard size USB port of the

Thuraya-XT hotspot (the current version of the XT-Hotspot requires a USB hub in the middle to

interface properly to lower speed USB devices like the Thuraya-XT phone). To charge the internal

battery, connect the power adapter cable to the micro-USB connector and plug the power-adapter to a

110/220 volt source. Turn the phone on and make sure it is registered and configured for GmPRS

connectivity. Move the XT-Hotspot on/off switch to the

WiFi LED will become a solid green. The XT-Hotspot will then attempt to establish a GmPRS

connection if it is configured for an always-on connection (default). Once a connection is established the

LED with the Internet symbol (LED closest to the edge) will start flashing once per second. Next turn on

your PC and scan for wireless networks. This procedure can be different for different Operating Systems.

For example on Windows XP, you can view the available WiFi networks by clicking the WiFi icon on the

right end of the bottom panel and then selecting "View Wireless Networks". The XT-Hotspot WiFi ID -

will appear. If it doesn't, wait for 10 seconds, and re-scan (Refresh Network List in Windows

Thuraya

XP). Once the

Thuraya

Start a web browser on the PC and see if you can access websites on the Internet. Once you are done with

the Internet session, turn off the XT-Hotspot or pull the Thuraya XT USB cable out to disconnect the

connection. If the Internet LED is blinking but you cannot connect to websites then your PC may not be

connected properly to the XT-Hotspot. If the Internet LED does not blink then the XT-Hotspot has not

been able to initiate a GmPRS connection. Review the troubleshooting section below to obtain the

information needed to diagnose the problem.

The XT-Hotspot can handle failures in GmPRS connectivity. For example, the XT-Hotspot can be

powered up without the Thuraya XT phone being connected to the XT-Hotspot. Plugging in the cable at

a later time will cause the connection to be initiated. Additionally if the GmPRS connection attempt fails

the first time, the XT-Hotspot will periodically attempt to establish a connection at a later time.

If you want to use the XT-Hotspot in wired mode, connect the PC's LAN port to the LAN port on the XT-Hotspot. Make sure that the PC is configured

to get an IP address automatically. Note that PCs are usually configured for automatic IP address assignment

Manage the Hotspot

Connect via WiFi to the

address

http://192.168.1.1

name root and password admin. Click the

ID appears, select it and click Connect.

ID as described earlier. Open up your web browser and enter the

Thuraya

in the address bar. The login screen will appear. Login to the router with user

Network

position. Once the XT-Hotspot is up the

tab to open up the

Chapter

page as shown in

Interfaces