Dyna-Glo WK11C8 Instrukcja obsługi - Strona 11

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Grzałka Dyna-Glo WK11C8. Dyna-Glo WK11C8 19 stron. Portable kerosene-heater
Również dla Dyna-Glo WK11C8: Instrukcja obsługi (18 strony)

Drukuj stronę

. Remove 4 wing nuts with flat

blade screw driver.

. Remove the wick by folding it to

the inside. Then remove the wick

sleeve from the bottom of the

assembly

. Line up the pins with the slotted holes inside the

wick adjuster. Then lightly press each of the

three pins of the wick (now attached to the wick

sleeve) toward the center, away from the slanted

grooves of the wick adjuster allowing the wick do

drop slightly. Once the pins line up with each

hole, press firmly on each pin toward the slanted

grooves securely through each hole.

. Lift the wick adjuster assembly

straight up and away from the

heater.

. Install the new wick and insert

the 3 pins on a new wick into

the 3 holes on the wick sleeve

in the upward direction. (See

the arrow marked "up" on the

wick sleeve)

Hole

. 1) Turn the wick adjustment knob to the fully raised

2) Pull lightly on the skirt of the wick to remove any

3) Press lightly to secure the skirt to the retaining and

4) You will need to hold the knob to keep the wick at

NEVER LEAVE THE HEATER

UNATTENDED WHILE BURNING!

. Hold the wick assembly up-side-

down, using caution, grasp the

wick cover firmly PULL it off with a

sharp tug. If you have difficulty

doing so, try loosening the wick

cover with a flat blade screwdriver.

CAUTION : The inside of wick cover

has sharp teeth. The use of work

gloves is suggested to avoid injury.

. Push the new wick into the

retainer teeth of the wick sleeve

so that the wick adheres tightly

around the inside ot the wick

sleeve, smoothing out any

wrinkles.

position.

slack.

remove any slack.

the highest position.

Wick cover