Hi-Force HEP103 Instrukcja obsługi
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Pompa wodna Hi-Force HEP103. Hi-Force HEP103 8 stron. Electric driven pump
Drukuj stronę
Description:
Hi-Force HEP series pumps are designed to
operate high pressure hydraulic cylinders
and tools with a maximum working
pressure of 700 bar. These instructions
cover all HEP series models. Refer to
nameplate on pump for the full model
identification.
Please read this instruction booklet
carefully before operating the product
and keep in a safe place for future
reference.
It is the responsibility of the purchaser to
ensure that operators are properly trained
in the safe use of this equipment and have
access to HI-Force Operating and Safety
Instructions.
No modification and/or additions may be
made to this equipment without the
written permission of the manufacturer.
It is expected that the product is used by
competent technical personnel who have
been properly trained to use hydraulic
lifting equipment
NOTE: Spare parts sheets for these
products are available from the Hi-Force
website at:
www.hi-force.com
or from your local regional Hi-Force Sales
office or authorized local Hi-Force
distributor.
1.0 Inspection of the product upon receipt:
On receipt of the product, visually inspect
the item for any evidence of shipping
Hi-Force Limited – Prospect Way – Daventry – Northants NN11 8PL – United Kingdom
Tel: +44(0) 1327 301000: Fax: +44(0) 1327 706555: Website: www.hi-force.com
INSTRUCTION MANUAL – Electric Driven Pump Series HEP:
Model Series: HEP1, HEP103, HEP2, HEP3, HEP5
damage. Please note shipping damage is
not covered by warranty. If shipping
damage is found notify the carrier
immediately and refrain from putting the
product into service. The carrier is
responsible for repair and replacement
costs resulting from damage in transit
shipment.
2.0 Safety Precautions:
Read and follow all the instructions and
safety warnings carefully prior to use of the
equipment. Failure to do so could result in
equipment damage or failure of the
equipment or personal injury. Hi-Force will
not be held responsible for any damage to
the equipment or personal injury resulting
from unsafe use of the product, lack of
maintenance or incorrect operation. If in
doubt on the correct usage of any Hi-Force
equipment, contact your nearest Hi-Force
office or distributor. If the operator has not
been trained on high pressure hydraulic
equipment and its safe use consult your
local Hi-Force sales office who can offer
you training courses for operators.
All
operators
should
necessary personal protective equipment
as specified by their employer is worn when
operating any hydraulic equipment. Safety
shoes, safety glasses/ visor and protective
gloves should be worn at all times. All
relevant
risk
assessments
completed prior to use of the equipment.
Warning: All ancillary equipment to
be used with these ranges of
hydraulic manual pumps MUST be rated
for use at the same operating pressure as
the pump model to be used:-
HEP12 series – 700bar (10,000psi)
HEP103 series – 700 bar (10,000psi)
HEP2, HEP3 &HEP5 series–700 bar(10,000psi)
Sufficient time should be allocated to
planning your hydraulic system.
ensure
that
all
should
be