Dyna-Lite MP1600 Instrukcja obsługi - Strona 3

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Power Pack Dyna-Lite MP1600. Dyna-Lite MP1600 12 stron.

Important Safeguards

When using this flash equipment, basic safety precautions should always be followed, included the following:

1. Read and understand ALL instructions and specifications before using your Dyna-Lite equipment.

2. Care must be taken when handling the flash heads as injury could occur from touching the

modeling lamp(s) or flash tube(s).

3. DO NOT operate a power pack or flash head with a damaged cord or if the unit has been dropped.

4. If an extension power cord is necessary, a cord with a suitable current rating should be used. Cords

rated for less than 15 amps may overheat. Care should be taken to arrange the cord so that it will not

be tripped over or pulled from the electric source outlet.

5. Unplug the power pack from the electrical outlet when not in use. NEVER yank the cord to pull

the plug from the outlet.

6. Let flash heads cool completely before putting them away. Loop flash cables in an 8" to 10"

diameter when storing.

7. DO NOT allow power cord(s) or flash head cable(s) to hang on or touch hot surfaces.

8. To avoid electrical shock hazard, DO NOT attempt to disassemble the power pack. Incorrect reassembly

could cause an electrical shock hazard when a power pack is subsequently used. Take it to a qualified

Dyna-Lite service technician when repair is required.

9. When the power pack is not in use for one month or more, it is wise to periodically plug the

power pack in and turn it ON for a couple of hours. It is not necessary to operate a flash head

during this "idling" time.

10. Use the flash head extension cable locking rings with the flash head pigtail not at power pack.

11. The use of properly GROUNDED AC outlet is recommended.

12. Remove plastic or metal flash head cover before shooting.

13. Please set the sync mode switch to the "SYNC" position before turning the power and model

lamp switches "ON" and "OFF". This procedure will ensure the longevity of the power and

modeling lamp switches.

Personal Records/Insurance

Date of Purchase ___________________________ Serial Number _______________

Dealer Name

____________________________ Phone _____________________

Address _____________________________

Insurance Company _________________________ Policy Number _______________