great gadgets Retro Call @1970 Bluetooth Instrukcja obsługi - Strona 2

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Telefon great gadgets Retro Call @1970 Bluetooth. great gadgets Retro Call @1970 Bluetooth 8 stron. Wireless telephone receiver for bluetooth enabled mobile phones

Drukuj stronę

English

How to get started & synchronisation with mobile phones

(continued from page 1)

Hold the Retro Call @1970 Bluetooth telephone receiver near your mobile phone and press

the ON/OFF button for approximately five seconds. The status light will light up in yellow

and red alternately. "Phone 01" will be shown on the display of your mobile phone once it

has recognised the Retro Call @1970 Bluetooth telephone receiver.

Confirm the "Phone 01" device on your mobile phone. After that, you will be prompted to

enter an ID. Type in "0000".

Once the Retro Call @1970 Bluetooth telephone receiver has been successfully synchro-

nised with your mobile phone, the red status light will indicate that the receiver is ready to

operate.

10.

You only need to register the receiver once. In order to use the receiver, please ensure that

Bluetooth is activated on your mobile phone, that the receiver is switched on and that the

product has been registered as a device.

Additional operating advice

Switch on: Press the ON/OFF button for approximately five seconds.

Answer calls: You can answer phone calls directly with the Retro Call @1970 Bluetooth

telephone receiver. Simply press the ON/OFF button. A beep confirms that the call has been

taken.

Make a call: Use your mobile phone as you normally would. Depending on the make, the

mobile phone might ask you if you wish to talk directly through your mobile phone or with the

receiver.

Adjust volume: You can adjust the volume whilst being on the phone. Simply press the

volume control buttons on your receiver.

Hang up: To hang up press the ON/OFF button. A beep confirms that the call has finished.

Switch off: Press the ON/OFF button for approximately five seconds. The status light displays

to confirm that the receiver has been switched off.

Reach: The reach between your mobile phone and the receiver is approximately ten meters.

Status light: Battery is being charged – red LED on

Battery fully charged – red LED off

Synchronisation with your mobile phone: red and yellow LED in turns

Bluetooth connection activated – red LED blinks slowly

Retro Call @1970 Bluetooth

Instruction Manual