Dynablast BEF series Instrukcja obsługi - Strona 7

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Myjka ciśnieniowa Dynablast BEF series. Dynablast BEF series 19 stron. Hot water

WASHING TECHNIQUES W/ FLOAT BOX

Check that the Soap metering valve is adjusted to the ratio you want.

Turn the Soap Induction metering valve to "on".

Start the Pressure Cleaner.

When the work area is covered, allow enough "dwell" time to maximize the effectiveness of the additive.

Turn the Soap metering valve to "off".

Rinse off soap.

Clean work area thoroughly with high pressure water, rinsing from bottom to top and then top to bottom.

NOTE - Most detergents and many additives are corrosive in full strength. It is good practice to remove

tubing from additive jug after use and place it in clear water. Open the pump additive valve and draw the

clear water into the line. Leave this tubing in clear water rather than the additive, if leaving for extended

periods.

NOTE - After many hours of operation, the hardened stainless steel nozzles supplied may wear and give

reduced pressure. Be sure to replace with the same size, or order from the dealer.

Check for SYSTEM LEAKS. Leaks in the pressure side of the system can cause premature wear (or even

failure) of the pump. The WARNING signal for this kind of leak is "frequent" cycling of the unloader.

("FREQUENT" means more than once every 2 minutes in the "Gun-Off" position.) Check the gun and swivel

joints for leaks.

Check the OIL LEVEL at least once a week. Add ONLY the type and grade of oil specified for this pump. (See

"Specifications and Features" sheet.)

CHANGE OIL as recommended.

After you use chemical additives, thoroughly FLUSH the system with clean water.

Inspect the POWER CORD regularly. Also check the POWER OUTLET SOCKET. For safety, replace worn or

damaged parts immediately.

Never run the washer without water. TURN WATER ON FIRST.

PROTECT FROM FREEZING! When transporting your washer in temperatures below 32°F (0°C),

WINTERIZE the pump, hoses and gun

AND SOAP INDUCTION UNIT

BEF

SERIES