Aircommand 5860001 Instrukcja obsługi - Strona 9

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Klimatyzator Aircommand 5860001. Aircommand 5860001 17 stron. Roof top air conditioner

9. Attach Plenum Cover

Connect the main cover of the plenum to the duct by

attaching the blue suspension cord to the lug on the inside

of the cover (Fig 13).

• This will allow you to use two hands to connect the

control cable (Fig 14).

• Connect the key pad control cables together (see below).

Be sure that the plug joins the corresponding wire colours

together (yellow to yellow, red to red etc).

Failure to properly plug the control cables together

correctly will result in loss of power to display.

• Secure the main plenum cover to the duct assembly with

the 4 screws provided (Fig 15).

TIP: Remove the ﬁ lters to make hole alignment easier.

(Fig 16).

• It is important that these screws are not over tightened

otherwise the plenum may crack.

• Remove the ﬁ lter elements by pulling them out of the

plenum, and use the six self tapping counter sunk screws

to secure the cover's edges to the caravan ceiling (Fig 16).

In some instances a very small pilot hole may need to be

drilled to guide the screws into place.

• Replace the ﬁ lters by sliding them into the plenum until

they click into place.

INSTALLATION IS NOW COMPLETE.

PROCEED TO COMMISSIONING.

Fig 13: Shows the positioning of the lug inside

the plenum cover.

Pull the suspension cord down from inside the

unit and hook it through the lug shown inside

the plenum housing. This will allow two free

hands to connect the control cables together.

Fig 14: Attaching the suspension cable will allow two hands

free to plug in the control cable.

Fig 15: Secure the main plenum cover to the duct assembly

with the four.

Fig 16: Remove the plenum ﬁ lters and use the six self tapping

screws to secure the plenum over to the ceiling of the caravan.

Be sure not to over tighten.