Hi-Force JCH21 Instrukcja obsługi

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Walety Hi-Force JCH21. Hi-Force JCH21 2 stron. Compact jacks

Drukuj stronę

Hi-Force Compact Jack Series: JCS and JCH

JCS Models have solid piston and are spring

assisted return.

JCH models have a hollow bore piston and are

gravity return.

JCS Compact Jacks:

JCH Compact Jacks:

All Hi-Force JCS and JCH series jacks are supplied

from the factory pre-filled with oil, and are ready

for use.

1.0 Inspection of the product upon receipt:

On receipt of the product, visually inspect the item

for any evidence of shipping damage. Please note

shipping damage is not covered by warranty. If

shipping damage is found notify the carrier

immediately and refrain from putting the product

into service. The carrier is responsible for repair and

replacement costs resulting from damage in transit

shipment.

2.0 Safety Precautions:

Read and follow all the instructions and safety

warnings carefully prior to use of the equipment.

Failure to do so could result in equipment damage

or failure of the equipment or personal injury. Hi-

Force will not be held responsible for any damage

to the equipment or personal injury resulting from

unsafe use of the product, lack of maintenance or

incorrect operation. If in doubt on the correct

usage of any Hi-Force equipment, contact your

nearest Hi-Force office or distributor. If the operator

has not been trained on high pressure hydraulic

equipment and its safe use consult your local Hi-

Force sales office who can offer you training

courses for operators.

Hi-Force Limited – Prospect Way – Daventry – Northants NN11 8PL – United Kingdom

Tel: +44(0) 1327 301000: Fax: +44(0) 1327 706555: Website: www.hi-force.com

INSTRUCTION MANUAL:

Model Series: JCS & JCH Compact Jacks

All operators should ensure that all necessary

personal protective equipment as specified by

their employer is worn when operating any

hydraulic equipment. Safety shoes, safety glasses/

visor and protective gloves should be worn at all

times. All relevant risk assessments should be

completed prior to use of the equipment.

Description:

This equipment is provided for the purpose of lifting

or lowering loads, or exerting a force, under the

control of a trained operator.

The equipment is supplied completely assembled

and ready for use. No service adjustments are

necessary or possible during operation.

An internal safety relief valve (factory set) is fitted

which limits the load that may be lifted to the

equipment rated load + 10% maximum.

Hydraulic Jacks must only be serviced by a

qualified technician.

To protect your warranty, only use Hi-Force's

hydraulic oil.

Immediately replace any worn or damaged parts

using genuine Hi-Force parts only.

Hi-Force JCS & JCH Jacks are despatched from the

factory pre-filled with oil, and are ready for use.

They can be used, if installed correctly, in any

position, for example sideways, upside down etc.

Available Models:

JCS Range:

JCH Range:

General Description:

The JCS jack has a solid piston and a spring to

retract the piston. The JCH jack has a hollow piston

to allow tensioning and pulling of studs etc, and the

piston must be pushed back manually or by the

load. Either style jack can be used, in any position,

Keep hydraulic Jacks away from flames and

direct heat.