Hi-Force IP1700 Instrukcja obsługi - Strona 7

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Sterownik udarowy Hi-Force IP1700. Hi-Force IP1700 10 stron. Pneumatic impact wrenches

1) Insert an airline connection into the air inlet (7) using PTFE tape if required. Details of the air inlet thread

sizes can be found in the specification chart, See specifications. An airline with an internal diameter of

13mm minimum is recommended for optimum tool efficiency.

2) Fit the supplied handle (not required on the IP850) to the torque tool. Hand, arm, vibration (HAV) figures

are taken from a tool with a properly fitted handle.

Figure 1

3) Connect the tool to the Filter, regulator and lubricator unit ("FRL" (recommended)) ensuring that the oil

reservoir has sufficient airline oil and the drop rate is set to approx. 1-2 drops every few minutes. This rate

can be adjusted to suit the tooling size and the environment. More details on the FRL units can be found in

the operating instructions supplied with the FRL unit and also in the Hi-Force catalogue and online at

www.Hi-Force.com.

Airline connections should be secured by a whip prevention system to avoid injury due to

whipping, if a failed component occurred.

4) Without the tool connected to any application or socket, and the regulator set to zero, depress the trigger

(4) and gradually turn up the regulator allowing the tool to free speed until the required max is reached. If

there are any signs of air leaks, stop the tool, dis-charge any residual air in the system and investigate the

leak.

NOTE: If the tool is to be used in cold conditions, has been stored in a cold environment, or has not been

used for a long period of time. It is recommended to allow the tool free speed, without the tool connected to

any application or socket, to allow it to come up to temperature and prevent seizing due to the oil viscosity

thickening in the tool.

5) The regulator can be used to decrease the operating pressure if the tools max range is not required, this

will reduce both the energy used and the energy required by the operator. Noise (dB) levels will be lowered

and the tools longevity will be greatly increased.

Operating Instruction Manual:

OM-IP-01

8.0 Installation / Setup

Serial Numbers:

BR2198

Figure 2

5mm