Daxten SCOUT 8 Instrukcja instalacji - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Przełącznik Daxten SCOUT 8. Daxten SCOUT 8 8 stron. 8 / 16 port kvm switch

Drukuj stronę

Reset

The SCOUT Switch can be reset without disconnecting or powering down your computers either by

pressing down Button 1 on the front panel for 2 seconds, or with the hotkey sequence Scroll Lock

Scroll Lock End

Note:

Each keystroke should be followed by its next keystroke within 2 seconds!

Note:

After you have set up cascaded SCOUT Switches, and you want to initialize this

setup for the first time, you should perform the reset on the first (master) switch (that is,

the first bank) to initialize. Also remember to turn on all the other switches on the daisy-

chain. The reason is that the first (master) switch will send message to the slave units. If

the slave units are not there to receive and respond to this reset message, system errors

will occur. If you want a reset later during your operation, you can do on the SCOUT's

other than the master unit.

Keyboard Hot Key commands

To send Hot Key commands to the SCOUT switch, press and release the Scroll Lock Scroll Lock

within 2 seconds. Press a command key for the desired effect. The following commands are

supported:

First Key

Second Key

Scroll Lock

In Auto-Scan mode, the image shown on the monitor will automatically switch to the next computer.

After the last computer has been shown, the first computer will be shown again.

Note:

In Auto Scan mode there is no mouse or keyboard control. Press any key to exit

the Auto-Scan mode. The SCOUT switch will stop at the last PC shown

Selection buttons

Pressing the individual PC buttons on the front of the SCOUT will switch the signal to the desired

computer.

Command Key

2 digit bank number +

2 digit port number

↑

↓

Page Up

Page Down

any key

Space Bar

End

Command Result

Switches to the desired PC

Switch to previous PC

Switch to next PC

Next lower unit (bank)

Next higher unit (bank)

Sound ON/OFF for Auto-Scan

Auto-Scan ON

Stop Auto Scan

Refresh EEPROM

Find PC by Name

Displays OSD

Reset KVM