Gaggenau VG 295 AU Instrukcja obsługi - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Płyta grzewcza Gaggenau VG 295 AU. Gaggenau VG 295 AU 12 stron.

Drukuj stronę

Operating principle

The gas cooktop features teo normal burners (two

flame rings), two high output burners (two flame rings)

and a wok burner (three flame rings).

The appliance features one-hand operation, automatic

fast ignition, electronic flame detection and automatic

re-ignition.

The ignition is activated when the control knob is

turned. The flame size can be set continuously

between high and low.

Operation

The markings show the position of the corresponding

burner and the setting between high and low heat. The

flame setting is infinitely variable between high and

low heat.

Notes

‒

Only light a burner if all pan supports and burner

parts are properly assembled.

‒

Make sure the burners and electrodes are clean

and dry.

‒

Only use the recommended accessories. Do not

cover the stainless steel cooktop base (e.g. with

aluminium foil).

‒

Do not cover the air inlet at the back of the

cooktop.

Abnormal operation

Flames are usually blue and sharply defined. If the

flames are yellowish or noisy or if the gas does not

ignite within the period specified under "switching on"

abnormal operation is indicated. Refer to chapter

"After-sales service" of this manual for service contact

details.

Caution! Heat damage to the extractor hood: Always

switch on the extractor hood while the gas cooktop is

in use. When using several cooking positions select a

higher fan level on the extractor hood. Make sure there

is a sufficient ventilation of the room.

Switching on

Your cooktop features automatic fast ignition.

Place a suitable pot or pan on the corresponding

cooking position.

Press down the corresponding control knob and

turn it anticlockwise to the required position. The

burner lights automatically.

The flame size can be set continuously between high

and low by slowly turning the control knob.

Notes

‒

When using large pots or pans you should ignite

the burner in the low position.

‒

Every time the gas hob is switched on, the

electronics run an auto test. All electrodes fire

and the required burner ignites after a few

seconds. When switching on further burners, only

the corresponding electrode fires.