Great Land DG1P61F Instrukcja obsługi - Strona 14

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Silnik Great Land DG1P61F. Great Land DG1P61F 17 stron.

Fuel

Gasoline will oxidize and deteriorate in storage. Deteriorated gasoline will cause hard starting, and it

leaves gum deposits that clog the fuel system. If the gasoline in your engine deteriorates during storage,

you may need to have the carburetor, and other fuel system components, serviced or replaced.

The length of time that gasoline can be left in your fuel tank and carburetor without causing functional

problems will vary with such factors as gasoline blend, your storage temperatures, and whether the fuel

tank is partially or completely filled. The air in a partially filled fuel tank promotes fuel deterioration. Very

warm storage temperatures accelerate fuel deterioration. Fuel problems may occur within a few months,

or even less if the gasoline was not fresh when you filled the fuel tank.

Fuel system damage or engine performance problems resulting from neglected storage preparation are

not covered under Warranty.

ADDING A GASOLINE STABILIZER TO EXTEND FUEL STORAGE LIFE

When adding a gasoline stabilizer, fill the fuel tank with fresh gasoline. If only partially filled, air in the tank

will promote fuel deterioration during storage. If you keep a container of gasoline for refueling, be sure that

it contains only fresh gasoline.

1.Add gasoline stabilizer by following the manufacturer's instructions.

2.After adding a gasoline stabilizer, run the engine outdoors for 10

minutes to be sure that treated gasoline has replaced the untreated

gasoline in the carburetor.

DRALNING THE FUEL TANK AND CARBURETOR

WARNING

Gasoline is highly flammable and explosive, and you can be burned or seriously injured when

handling fuel.

.Stop engine and keep heat, sparks, and flame away.

.Refuel only outdoors.

.Wipe up spills immediately.

1.Place an approved gasoline container below the carburetor, and use a funnel to avoid spilling fuel.

2.Remove the drain bolt, then move the fuel valve lever to the

ON position.

3.After all the fuel has drained into the container, reinstall the drain bolt and washer. Tighten the drain

bolt securely.