Dynabrade 56802 Instrukcja obsługi - Strona 5
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Sander Dynabrade 56802. Dynabrade 56802 8 stron. Small grip dynorbital supreme random orbital sander
Drukuj stronęBuy parts on line at https://Dynashop.co.uk/ for all things Dynabrade
Motor Assembly/Disassembly Instructions – Dynorbital
Drawing 4
Valve and Speed Regulator Assemblies:
1. Secure housing in vice using 57092 Collar or padded jaws.
2. Remove inlet bushing, 01468 Spring, 01472 Tip Valve and 01464 Seal from housing.
3. Remove 95697 Snap Ring. Press the spread regulator and valve stem out of the housing. Remove the 01025 O-Rings (2).
4. Place new 01025 O-Rings (2) on the speed regulator and place in housing with valve stem. Install new 95967 Snap Ring.
5. Place new 01464 Seal in housing. Using tweezers or needle nose pliers, place the tip valve into housing so that the pin goes through the valve stem
hole. Place new 01468 Spring into housing so small end is towards tip valve.
6. Spread small amount of #567 Loctite
Note: Motor should operate at between 9,500 and 10,000 RPM at 6.2 bar (90 PSIG). RPM should be checked with a reed tachometer. Before operating, we
recommend that 2-3 drops of Dynabrade Air Lube P/N 95842 (or equivalent) be placed directly into the air inlet with throttle lever depressed. Operate the
machine for approximately 30 seconds before application to workpiece to determine if machine is working properly and safely and to allow lubricating
oils to properly dispense through machine.
Loctite
®
is a registered trademark of the Loctite Corp.
Disc Pad Change:
1. Insert 50679 Wrench on flats of 57069 Balancer Shaft and twist off sanding pad by hand.
2. With wrench still in place, hand tighten new pad on tool.
3. No need to remove shroud or overskirt.
Required Weight of Pads:
3-1/2" Models –– Use pad weighing 80g.
5" Models –– Use pad weighing 100g.
6" Models –– Use pad weighing 130g.
96024 Motor Tune-Up Kit:
Includes assorted parts to help
maintain and repair motor.
Buy parts on line at https://Dynashop.co.uk/ for all things Dynabrade
57091
Bearing Press Tool
57057
Front Bearing Plate
57088 Bearing
Motor Shaft Balancer
Balancer Shaft Assembly
®
(or equivalent) around the threads of the first inlet bushing and tighten into housing to 23 N•m/200 in. - lbs.
Optional Accessories
Drawing 5
57098 Motor Repair Kit:
Includes special tools for proper disassembly/assembly of
the Dynorbital
®
Supreme.
5
®
Supreme Sander
57091
Bearing Press Tool
57056 Rear Bearing Plate
(with 01206 Bearing)
Line-Up Pin
57058 Cylinder Assembly.
(w/Rotor and Vanes)
57057 Front Bearing Plate
(with 57088 Bearing)
Motor Shaft Balancer
Balancer Shaft Assembly