Agriframes 39100-TBK Instrukcja montażu - Strona 4
Przeglądaj online lub pobierz pdf Instrukcja montażu dla Meble zewnętrzne Agriframes 39100-TBK. Agriframes 39100-TBK 5 stron.
Drukuj stronęPlease read these instructions carefully.
Assembly Requires: a Rubber Mallet, an Allen Key (provided), a Ladder, Spirit Level, Pliers and a Tape Measure.
Step 1:
Before assembly check the cross poles to ensure the grub screws are inserted into the holes on the ring clamps.
o Loosen these grub screws ½ way out of the hole, to ensure when the ring clamps are moved into position the grub screw does not scratch the outer
coating of the metal.
Slide a moisture seal onto the reduced ends of all the vine arch curves.
Connect the reduced ends of 2 Vine Arch curves into the roof connectors, cover the joins between the poles with moisture seals. Repeat this process with
all of the Vine Arch Curves.
Slide a Cross pole onto the Vine Arch curves, on the outside of the arch.
o Starting with the top cross poles, these poles should be positioned towards the join of the curves. Once you are satisfied with the cross poles
position tighten the grub screw.
o The second cross pole needs to be placed 40" below the top Cross Pole, to allow for the lattice infill. This may require the second cross pole to be
positioned on the join between the curve and the upright.
Slide a moisture seal over the end of the curve.
Attach the small end plug to the ends of the Cross poles.
Attach the lattice using the cable ties, once the ties are secured trim the excess.
Step 2:
Once the top of the arch has been completed move the structure to where it is to be installed and, firmly push the structure into the ground to make an
impression, indentation or mark to indicate where the uprights should be placed. Then remove the top structure and check that the marks can clearly be
seen.
Step 3:
Using the hole-maker create a hole 15" into the ground, where you have marked or indented the ground previously, ensure that the holes are vertical and
to the same depth.
Insert the end plugs into the non-reduced ends of the 6 uprights, then insert these uprights into the hole in ground, with the end plugs going into the soil.
Assembly Instructions for Classic Extra Vine Arch Matt Black