GREAT PLAINS 706NT Instrukcja obsługi - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Sprzęt rolniczy GREAT PLAINS 706NT. GREAT PLAINS 706NT 6 stron. End wheel no-till

5.) Locate the desired seeding rate for the type of seed on the chart in the owner's

manual or on the lid of drill.

A. Set the drive type for the seed and rate desired.

B. Loosen wing nut on seed rate adjustment handle and move it past the

required number and then back to the correct number on the brass plate.

C. Check seeding rate by running the calibration procedure outlined in owner's

manual or on the seed rate chart of drill lid.

NOTE: The gear box has four drive types. Refer to the operator's manual for the

correct drive for a given seed. If the desired rate is not given, it is possible to refer to

the drive type rates and shift to a new drive type.

6.) Heavy duty down pressure springs are standard equipment. The "W" clips are

shipped from the factory in the bottom hole and should be left there in all

applications. The "W" clips can be raised one hole in the wheel tracks in extreme

conditions. NOTE: If the "W Clips are raised too high, spring pressure increases

accordingly. This will take away weight available to penetrate the coulters.

7.) The depth of each opener is controlled by the height of the press wheel. Varying

the height of the press wheel changes the seeding depth. Moving the "T" handle to

the front of the opener shallows the depth; moving the "T" handle towards the rear

of the opener increases the depth. For a starting point place the "T" handle in

center.

MAIN SEEDBOX DRIVE TYPE RATIOS

Drive Type 2 is 2.06 times faster than drive 1

Drive Type 3 is 3.08 times faster than drive 1

Drive Type 4 is 5.03 times faster than drive 1